Table of Contents
Advertisement
Throttle Curve
Flight Mode
Normal Mode
Exponential
Off
Point
Point - 1
Status
0.0% 0.0%
d
eUention
Welcome to use the DEVO F12E transmitter
DEVO Fl 2E
(1) Flight Mode
There are total five flight modes: Normal Flight, Stunt 1, Stunt 2, Stunt 3 and Stunt 4. The Curve of which
can be respectively set in their corresponding flight mode. The setting method is to press UP or DN to select
Flight Mode in Throttle Curve interface. The corresponding flight mode will be shown when the Flight Mode
switch shifts via pushing or pulling the Flight Mode Switch. And the exponential can be adjusted after Flight
Mode is selected.
Throttle Curve
(2) Exponential setting
Press UP or DN in the "Throttle Curve" setting interface to select
"Exponential" setting, Press R or L to set "Off" or "On". The throttle curve
will being changed smoothly if select On. Select Off if not need then the
throttle curve will be shown as a line.
(3) Curve setting
It includes two items: Point and Output.
Flight Mode
Normal Mode
Exponential
Point
Point - L
Output
0.0%
0.0% 0.0%
(3.1) Point setting
Press UP or DN in Throttle Curve interface to select Points setting. Press
R to expand a list including seven points: "Point-L", "Point-1", "Point-2",
"Point-M", "Point-3", "Point-4" and "Point-H". Press R or L to select the
point you want to adjust.
(3.3) Output adjustment
An expansion list of Output and Hover items will be shown after activating
the Status. Press UP or DN to move navigation mark to select Output
item. And press R or L to increase or decrease the amount of selected
point with a minimum of 0.0% and a maximum of 100.0%.
Throttle Curve
Flight Mode
Normal Mode
Exponential
Off
Point
Status
Inhibit
0.0% 0.0%
Throttle Curve
Flight Mode
Normal Mode
Exponential
Off
Point
Point - 1
Status
Active
Output
Hovering
On
0.0% 0.0%
(3.2) Status setting
Press UP or DN to move navigation mark to Status and press R or L to
choose Inhibit or Activate. Select Inhibit if keeping the current value(the
default setting is Inhibit). Select Active for changing the above points'
value.
Note: After select point -L or Point-H, the status setting won't be display.
(3.4) Hovering Adjustment
After the setting of (3.3) Output adjustment is finished, it's necessary to set the item of Hovering as On and
all the selected points of the throttle curve should be activated if using throttle trim in flight is a must.The five
points of 1-2,M,3-4 in the curve will being paralleled or down with the changing of throttle trim. So the throttle
curve will being paralleled up or down with the movement of the five points.
Press EXT to exit after finish the setting.
3.7 Mix to throttle
This Function can keep the main rotor blades running at the certain revolution caused by the changed load when
operation the aileron servo, elevator servo and rudder servo. Generally, it's not advised to use the function.
Setting method:
Press ENT to enter Main menu. Press UP or DN to move navigation mark to select Function Menu. Press
ENT to enter function menu. Press UP or DN to select Mix to Throttle. And press ENT to enter Mix to throttle
interface as in below illustration.
DEVO F I 2E —34
Advertisement
Table of Contents
