Table of Contents
Advertisement
Model Reset
Model All
07
Model 07
ni 11.
n4
arning
No. 01 4P Model 01
Are you sure?
cleention
DEVO Fl 2E
Welcome to use the DEVO F12E transmitter
Single reset: Press UP or DN to choose the model you want to restore, "Are you sure?" will appear after press
ENT. Press ENT to reset or press EXT to exit.
2.6 Type Select
This device offersthree model types menu. They are Helicopter, Airplane and Glider respectively.
Press ENT to enter Main Menu and press UP or DN to select Model Menu.
Press ENT to enter and press UP or DN to select Type Select and press
ENT to enter setting interface.
Press "ENT" button to get Helicopter, Airplane and Glider selections and
press UP or DN to select and press ENT to confirm, then press EXT to
exit.
2.7 Trim System
Type Select
g
Helicopter
Glider
Trim System is able to finely tune the following six items, respectively: Elevator, Aileron, Rudder, Throttle,
Left Trim and Right Trim. The trim range is divided into 20 grades (factory default is set at 4). It is convenient
to subtly modify the pitch by adjusting the trim range.
Press ENT to enter Main Menu and press UP or DN to select Model Menu. Press ENT to enter and press
UP or DN to select Trim System, press ENT to enter Trim System setting interface. Press UP or DN to select
the trim which will set, press R to increase the trim value and press L to decrease.
Trim System
Elevator
4/20
Normal
Aileron
4/20
Normal
Rudder
4/20
Normal
Throttle
4/20
Normal
2.8 Stick Position Switch
For elevator, aileron, and rudder, there are two more options: Normal
and Limited, press R or L you can change the setup. "Normal" means
the trim is always working although the corresponding stick stays anywhere.
"Limited" means the trim is out of working when the corresponding stick
is at maximum position.
Press EXT to exit after finished.
According to the following setting, the switch can be used as a switch. The turn-on or turn-off position at which
stick stays can also be settable.
Stick Position Switch
Method for setting:
Press the ENT to enter Main Menu and press UP or DN to select Model
Menu. Press ENT to get Model Menu and press UP or DN to select Stick
Position Switch, press ENT to enter Stick Position Switch setting interface.
There are four options under the Stick postion switch: SPSO, SPS1,SPS2,
SPS3. Press R or L to choose the switch you want to define.
Switch
SPSO SW
Channel
Inhibit
DEVO F- 1 2E —55
Advertisement
Table of Contents
