Sensor View - devention DEVO F12E User Handbook Manual

Sensor View
4 2
Sensor View
2
Voltage Temperature
Inhibit Inhibit
Inhibit Inhibit
Inhibit Inhibit
Inhibit
Rate Sensor GPS Sensor
Inhibit Inhibit
Inhibit Inhibit
00:00 Inhibit Inhibit
=
=
Inhibit Inhibit
Inhibit Inhibit
cleention
Welcome to use the DEVO F12E transmitter
DEVO F 1 2E
Press UP or DN to select Elevator on the Fail Safe interface, then press
R or L to change the status of Servo Hold into Fail Safe(If you want to
keep Servo hold status, there is no need to re-set). There is a expanded
sub-item blow. Press UP or DN to select 0%, then press R or L to increase
or decrease, respectively, the position amount which centers on the
neutral point of servo. The available value is 125%, respectively. 0% is
the neutral point of servo.
The setting methods for other channels are same as above.
Press EXT to exit after finished.
Fail Safe
Elevator ME:132ai
0%
Aileron
Servo Hold
Throttle Servo Hold
Rudder Servo Hold
Note: checking whether all the actions when fail safe happened are correct, is a must after the setting is
finished. It is dangerous to use full throttle, especially after fail safe taken place.
3.20 Sensor View
Setting method:Press ENT to enter the Main Menu and press UP or DN to move the navigational mark to
select Function Menu.Then press
ENT to enter the Function Menu and
press UP or DN to select Sensor
View, then press ENT to enter the
Sensor View interface, like below
pictures. If all the sensors disconnect,
telemetry signal lost, there will be
inhibits shown on the view. If all work
normal, all the measured data will be
shown.
(1) Voltage: Show 3 diffferent measured voltage value;
(2) Temperature: Show 4 different measured temperature value;
(3) Rate Sensor: Show 2 different measured RPM value;
(4) GPS image display: in the interface of Sensor View, press DN to go to GPS image display. It will show:
local time, longitude, latitude, altitude, move speed, and battery Volume. If you set the image as the
background, these informations will be seen from the image.
Sensor View
Voltage Temperature
0-5.3V
0r-4- Alam temperature T1 display
v11.8V
3 °C-41
Alam temperature T2 display
0.
0.0V
4V4I Alam temperature T3 display
4°C-4 Alam temperature T4 display
Rate Sensor GPS Sensor
0 RPM 12-06-2014.4
Local date display
0-0
RPM 08:12:354 Local time display
Internal: VO power display
Exterior: V1 power display
Exterior: V2 power display
Rate R1 display
Rate R2 display
Timer display
display volume
Battery
Sensor View
00:53 12.1V 302m
Horizontal distance display
Altitude display
31m 10.0Km/to
Move speed display
Longitude display 104° 15.5123E 22° 06.0902N4
Latitude display
DEVO Fl 2E — 81