Table of Contents
Advertisement
Gyro Sensor
Channel
Cruise Mode
Speed Mode
Thermal Mode
Launch Mode
Land Mode
Land Mode
AUX2
50.0%
50.0%
50.0%
50.0%
50.0%
clXention
DEVO F1 2E
Welcome to use the DEVO F12E transmitter
(3) Status:
Turn the Flight Mode Switch, the status display present flight mode position.There are "Cruise Mode","Speed
Mode","Thermal Mode", "Launch Mode", "Land Mode" sets.
(3.1) Cruise Mode:
Press UP or DN to select Cruise Mode, press R or L can increase or decrease the value individually. If the
gyro used has two modes of NOR and AVCS, NOR will be activated when the value is less than 50.0%. In
NOR mode, the smaller the value is, the bigger the gyro sensor sensitivity will be; In AVCS Mode, the bigger
the value is, the bigger the gyro sensor sensitivity will be. The factory setting is 50.0%.
Display present flight mode position
(3.2) "Speed Mode", "Thermal Mode", "Launch Mode", "Land Mode" 4 settings refer to "Cruise Mode".
After finishing the set, press EXT to exit.
3.11 Rudder to Spoiler Mix
When this function is activated, the spoiler can be used as Rudder in the models without Rudder and can
also be mixed. The mix gain can be independently set in each flight mode, which should be previously set
at Device Select in Model Menu (Refer to "2.9 Device Select"), and "Dual Spoilers" should also be activated
at Wing Type (Refer to "2.11 Wing Type").
Rudder to Spoiler Mix
Setting method:
Press ENT to enter Main Menu; Press UP or DN to move the navigation
mark to Function Menu, and press ENT to enter Function Menu. Press
UP or DN to choose Rudder to Spoiler Mix and Press ENT to enter
Rudder to Spoiler Mix interface. Picture as right:
Land Mode
Cruise Mode
0.0%
Speed Mode
0.0%
Thermal Mode
0.0%
Launch Mode
0.0%
Land Mode
0.0%
There are five flight modes: Cruise Mode, Speed Mode, Thermal Mode, Launch Mode, Land Mode. Press
UP or DN to move the navigation mark to select the desired flight mode. Press R or L to increase or decrease
amount respectively. The adjustable range is from 0.0% to 100.0% and the default setting is 0.0%.
After finishing the set, press EXT to exit.
3.12 Aileron to Rudder Mix
This function aims at mixing the rudder when operating the aileron. The mix value can be respectively set in
each flight mode. But the flight mode should be previously set at Device Select in Model Menu (Refer to "2.9
Device Select").
Aileron to Rudder Mix
•7
2
Setting method:
Press ENT to enter Main Menu; Press UP or DN to move the navigation
mark to Function Menu, and press ENT to enter Function Menu. Press
UP or DN to choose Aileron to Rudder Mix and Press ENT to enter
Aileron to Rudder Mix interface. Picture as right:
Land Mode
Elevator Stick =Mir
Rudder Stick
Inhibit
Cruise Mode
Left
0.0%
Right
0.0%
DEVO F 1 2E — 104
Advertisement
Table of Contents
