Table of Contents
Advertisement
Frequency status
indicator
Switch button
cleOention
DEVO Fl 2E
Welcome to use the DEVO F12E transmitter
(2) Setting method
After TX and RX binding, press the switch with the tool pen
or screwdriver, both indicators will turn on. About 5 seconds,
both indicator will flash, then release the switch and press
it once again, the frame rate can be changed and the indicators
will turn red or blue only. Red means 22ms frame rate and
Blue means 11ms.
12.0 Installation requirement for DEVO F12E battery pack
Install the DEVO F12E transmitter battery, show as below picture, offering three kinds of power supply sockets,
plug according to the power fool-proof plug. The battery can be 7.4V Li-po battery or 11.1V Li-po battery.
The size of battery box: 38x31x100mm.
Warning: Do not put the polarities of batteries in the opposite directions.
When insert the battery box connector to the transmitter connector, pis make sure the fool-proof is right,
showing as below picture.
3pcs Li-po battery balance head power socket
2pcs/3pcs Li-po battery JST plug power socket
2pcs Li-po battery balance head power socket
Note:lf you don't use the transmitter, please take out the battery.
12.1 DEVO F12E Baftery Charging
Warning: the CHG socket is only used for the rechargeable NIMH batteries. If using the batteries which is
unchargeable. The CHG socket is not allowed to use.
CHG Charge socket: input DC at
12V, 50mA; Polarity:(90
DEVO Fl 2E —16
Advertisement
Table of Contents
