Table of Contents
Advertisement
cleention
DEVO F12E
Welcome to use the DEVO F12E transmitter
Display
present flight mode
(1) Status
Toggle the Flight Mode or Thottle Hold switch, the status display present
flight mode position.There are "Normal Mode", "Stunt 1", "Stunt 2", "
Stunt 3", "Stunt 4", "Throttle Hold" and so on."Throttle hold" need to
start that can effect.(refer to "3.5 throttle hold")
Governor
1Normal Mode
Channel
Gear
Normal Mode
0%
Stunt 1
0%
Stunt 2
0%
Stunt 3
0%
Stunt 4
0%
Throttle Hold
0%
(2) Channel: displaying in "2.10 ou put" have set the Channel.(refer to 2.10 Output)
(3) Normal Mode
Press "UP/DN" to make the navigation choose the "Normal Mode"set, press R/L to increase/decrease the
value.The factory default value is 0%.
(4) The method to set "Stunt 1","Stunt 2", "Stunt 3", "Stunt 4 ", "Throttle Hold" refer to "Normal Mode".
After the set finished, press EXT to exit.
3.10 Tail Curve
This function is mainly used for amending the reaction torque produced by pitch angle of main rotor blades.ln
the set flight mode,the mix amount can be automatically switched when moving the flight mode (FMOD)lever.
Press ENT to enter the Main Menu; Press UP or DN to make the navigation mark to choose the Function
Menu, then press ENT to the Functional Menu. Press UP or DN to choose "Tail Curve", then press ENT,
there will be shown an enqury of "all
Servo hold?" select ok for locking the
current status of all the Servos, and
cancel for unlocking the current status
of all the Servos; After finish the
choose, press ENT to "Tail Curve"
interface.There are current flight
mode status, and adjustable items.
Tail Curve
Warning
All Servos Hold?
Ok
Canc
Tail Curve
Flight Mode
Normal Mode
Pitch
Normal
Exponential
Off
Point
Point - 1
Status
Inhibit
(1) Flight Mode
-100%
0%
In the "Tail Curve" interface, press UP/DN to make the navigationg mark choose "Flight Mode" set .Toggle
the flight mode switch and shown the current flight mode. In the set of flight mode can set "pitch","exponential
curve","curve point setting",and "output "items.
(2) Pitch
Press UP/DN to make the navigation mark choose "Pitch" set, press R/L to choose the two options Normal
and Original. Select the desired item.
(3) Exponential Curve
Press UP/DN to make the navigation mark choose "Exponential" set, press R/L to choose two options On and
Off.The curve will be smoothly changed if touching on. Select the desired item.
(4) Curve Point Setting: Press UP/DN to make the navigation mark choose "Point" set.
(4.1)
Point Selection
Press R/L to set the Curve Point options "point-L", "point-one", "point-2",
"point-M", "point-3", "point-4", "point-H", totally seven options; Select the
point which you want to adjust.
Tail Curve
2
Flight Mode
Normal Mode
Pitch
Normal
Exponential
Off
Point
Status
Inhibit
-100%
0%
DEVO F1 2E —37
Advertisement
Table of Contents
