Table of Contents
Advertisement
Isar alms
Flight mode
111,1 41
WM
cleUention
DEVO F 1 2E
Welcome to use the DEVO F12E transmitter
(5) Automatic setting
Under working with Flight Mode, it's possible to switch the Dual Rate and Exponential, which are set in
above"(3) Dual Rate adjustment" and "(4) Exponential adjustment", respectively.
The setttings for Cruise Mode, Speed Mode, Thermal Mode,
Launch Mode and Land Mode 5 are available.
Note: If want to use this function, it is necessary to previously
set both "Flight Speed Switch" and "Flight Launch Switch" at
Device Select in Model Menu as the corresponding switches.
Refer to "2.9 Device Select".
5.1) Cruise Mode setting:
Press UP or DN in the navigation mark of Dual Rate and Exponential to
select the desired item Cruise Mode. Press R or L to set the position and
the Switch. Only the D/R switch control is valid When Switch is selected,
under the Flight Mode, it's possible for Pos to switch the Dual Rate and
Exponential, which are set in above(3) and (4)Exponential adjustment.
The settings for Swtich, PosO, Pos1, Pos2 , Pos3, Pos4 are valid.
Dual Rate and Exponential
Pos 0
Channel
Elevator
Position
Pos 0
Dual Rate
100%
Exponential
Line
Cruise Mode
Speed Mode
Switch
Thermal Mode
Switch
(5.2) The setting for Speed Mode, Thermal Mode, Launch Mode, Land Mode can be set up according to above
Cruise Mode Setting. Press EXT to exit after finishing the setting.
3.5 Motor Hold
The Motor Hold can be switched after the function is used. The setting range of Motor Hold is from -10% to
100%. The item Motor should be previously set at Device Output in Model Menu, which is used as Spoiler
Stick and is activated. Refer to "2.10 Device Output".
Motor Hold
Setting method:
Press ENT to enter Main Menu; Press UP or DN to move the navigation
mark to Function Menu, and press ENT to enter Function Menu. Press
UP or DN to choose Motor Hold and Press ENT to enter Motor Hold
interface.
Hold Position
cignIM
Switch
Off
(1) Hold Position
In the Motor Hold interface, press UP or DN to move the Navigation mark to choose "Hold Position" setting
options. Press R or L to increase or decrease the amount respectively. The adjustable range is from -10.0%
to 100.0% and the default setting is 0.0%.
(2) Switch Selection
Press UP or DN to choose the navigation mark of Switch setting item and press ENT to enter the select
interface of Switch. Press UP or DN
Motor Hold
to select the switch you want and a
"A/ " will be shown in its left. If two or
more switches are chosen, the item
"And" should be selected. Press EXT
to exit after setting up finished.
3.6 Flaperon Mix
This function is used to Mix Aileron to Flaperon, or Mix Elevator to Flaperon. The Mix amount can be
independently set in each flight mode.
The Flap Rate in each flight mode should be previously set before using this function. Refer to the following
"3.16 Flap Rate".
DEVO F 1 2E — 100
Switch
Hold Position
0.0%
Switch
MEMi
Cruise Mode
Speed Mode
Thermal Mode
Launch Mode
Land Mode
ELEV D/R
AILE D/R
Advertisement
Table of Contents
