Table of Contents
Advertisement
V Always On
Normal Mode
Stunt 1
Stunt 2
Stunt 3
Stunt 4
GEAR SW
Gyro Sensor
Mode
Channel
Switch
Pos 0
Pos 1
Pos 2
Pos 0
=MEI
AUX2
MIX SW
50.0%
50.0%
50.0%
c1Xention
DEVO F 1 2 E
Welcome to use the DEVO F12E transmitter
There are three settings: elevator, aileron and rudder. If the item of
Channel is shown as Elevator, there are UP, DOWN and Switch in the
interface. If the item of Channel is Aileron or Rudder, the contents in the
said interface will be changed into Left, Right and Switch. Take the
example of Channel set as Elevator to illustrate the setting method.
Mix to Throttle
g
Elevator
Up
Down
0%
Switch
On
Aileron
Left
0%
Right
0%
Switch
On
(1) Up setting
In the Mix to throttle interface, press UP or DN to move the navigation mark to select UP item. Press R or L
to increase or decrease the mix amount when moving the throttle stick upwards.The bigger the amount is,
the bigger the mix to throttle will be. Change the amount from "+" to "-" for the throttle mix direction Reversing.
The adjustable range is ±125%.
(2) Down setting
In the interface of Mix to Throttle, press UP or DN to move the navigation mark to select Down item. Press
R or L to increase or decrease, respectively, the mix amount when moving the throttle stick downwards. The
bigger the amount is, the bigger the mix to throttle will become. Change the amount from "+" to "-" for the
throttle mix direction Reversing. The adjustable range is ±125%.
(3) Switch Selection
Switch
In the interface of Mix to Throttle, press UP or DN to move navigation
mark to select Switch item. Press ENT, an expansion list of Always on,
Normal Mode, Stunt 1, Stunt 2, Stunt 3, Stunt 4 and Gear is shown. After
setting finished, Aileron or Rudder can be set via pressing DN.
(4) The setting of Aileron or Rudder, and Mix to Throttle can be referred
to Elevator setting. Press EXT after setting finished.
Note:
(1) Before the flight, please confirm: All above amount of mix to throttle is proper enough to offer a good flight.
And make sure all the actions in different flight mode are normal.
(2) The function is in spare when governor is working.
3.8 Gyro Sensor
This function supply the GYRO sensitivity adjustment,both through switch 'D/R' to Manual and "Flight Mode
"Automatic switch different sensitivity.
Setting method:
Press ENT to enter Main menu. Press UP or DN to move navigation mark to select Function Menu. Press
ENT to enter function menu. Press UP or DN to select Gyro Sensor. And press ENT to enter Gyro Sensor
interface.
(1) Manual Setting
(1.1) Manual Setting
In the Gyro Sensor interface, press UP/DN to choose "mode"project set,
press R/L to selectable set ("Manual set" and "Automatic set").Then
choose "Manual" option.
(1.2) Channel
The original channel is "AUX2", if you want to change to other channels
control, you can choose from "Output"set.(refer to "2.10 Output").
(1.3) Switch choose
In the Gyro Sensor interface, press UP/DN to choose "Switch "project set, press R/L to selectable sets "FMOD
SW", MIX SW, ELEV D/R, AILE D/R, RUDD D/R,GEAR SW, totally 6 selectable sets.Choose the Manual
control switch.
DEVO Fl 2E — 35
Advertisement
Table of Contents
