devention DEVO F12E User Handbook Manual page 59

Wing Type
Wing Type
V-Tail
Dual Channels
Mate
Trim
Twin Engine
Trim
Normal
Inhibit
Elevator
=Mk
Inhibit
Inhibit
Inhibit
Wing Type
Wing Type
V-Tail
Dual Channels
Mate
Trim
Twin Engine
Trim
Normal
Inhibit
Elevator
AUX4
Inhibit
Inhibit
cleention
DEVO Fl 2E
Welcome to use the DEVO F12E transmitter
(3) 4-Aileron
If your model airplane is equipped two left aileron servos and two right aileron servos, we recommand you
to use 4-Aileron function.
Press R or L to choose 4-Aileron in Wing Type setting. The channel assignment(Refer to Servo monitor):
The left aileron servos should be connected to the Output GEAR and AUX3 in the receiver, and the right
aileron servos connected to AILE and GYRO in the receiver.All the servos' parameters can be adjusted
respectively.
(4) V-tail
Press UP or DN to move navigation mark to V-TAIL under V-Tail interface. There are Inhibit and Active, please
choose Active. V-tail is unadjustable when the Wing type is Delta.
Below is the sketch map of servos' assignment in V-tail:
Left empennage Right empennage
Connect to the output ELEV in Receiver 411.111 911 1 11111111 1 0 Connect to the output RUDD in Receiver
(5) Dual channels setting
Dual Channels can be set as Elevator, Aileron, Rudder, or Flaperon. It is of dual channel output function.
The channel, which will be set as dual channel at AUX in Device Output (Refer to "2.10 Device Output"),
should be previously set as Inhibit when the AUX channel is being set.
Wing Type
Channel setting: Press UP or DN to move the navigational mark to item
Dual Channels in the interface of Wing Type. Pressing R or L, there are
items of Elevator, Aileron, Rudder, and Flap. We take Elevator as an
example.
(5.2) Trim Setting:
Press UP or DN to select "Trim Channels" setting, press R or L to select
the item you want to choose as trim lever in the menu with Inhibit, Left
trim, Right Trim, AUX4 KB, AUX5 KB, AUX6 KB, AUX7 KB.
Attention: Trim can only be enabled after starting Mate.
Wing Type Normal
V-Tail Inhibit
Dual Channels
Mate Inhibit
Trim Inhibit Inhibit
Twin Engine Inhibit
Trim Inhibit
(5.1)
Mate setting:
Press UP or DN to select "Mate Channels" setting, press R or L to select
the desired channel in the menu with Inhibitt and the inhibited channels
previously set in "Device Output".
The setting of Aileron, Rudder and Flap in the item Channel are same as above.
DEVO Fl 2E —59