Battery; About; Model Menu; Model Select - devention DEVO F12E User Handbook Manual

Hide thumbs Also See for DEVO F12E:
Table of Contents

Advertisement

2
Battery
Alarm
Press "ENT" to the Main Menu, press UP or DN to select System Menu,
then press ENT to System Menu. Press UP or DN to select About and
press ENT to the About setting interface.
1.10 About
Press EXT to exit after finished.
Low Voltage Warning: Please set up the low voltage warning value
when you turn it on following the battery specification.
Battery voltage
Li-Po battery
7.4V
Li-Po battery
11.1V
Dry battery
8x1.5V
Advised warning
voltage
6.4V
9.6V
8.0V
2.0 Model Menu
About
Hardware Ver. 1.0
Software Ver. 0.4B
cleention
DEVO F12E
Welcome to use the DEVO F12E transmitter
Press ENT button to enter the calibration, Repeat to shark the left and right of the remote control sticks from the
rock bottom to highest respectively for several times and then back to the rocker. Press ENT to confirm , if your
action is wrong, will display "please Retry!" ; If correct, display "calibration success!" . And then press EXT exit.
Stick Calibration
ENT to Finish
Stick Calibration
ENT to Finish
Please try again!
Stick Calibration
ENT to Finish
Calibration Success!
1.9 Battery
Battery voltage can set up the warning value for radio battery in lower voltage.
Press ENT to the Main Menu, press UP or DN to select System Menu, then press ENT to System Menu. Press
UP or DN to select "Battery" and press ENT to the Battery setting interface. Warning voltage value can be
changeable by R or L button.
Model Menu manages all the model data saved in DEVO F12E. It includes Model Select, Model Name, Model
Copy, Model Transmit, Model Receive, Model Reset, Type Select, Trim System, Stick Position Switch, Device
Select, Device Output, Swash Type, Power Amplifier, Fixed ID and Sensor setting.
2.1 Model Select
Press ENT to enter Main Menu and press UP or DN to make Model Menu is selected. Press ENT to get the
Model Menu and press UP or DN to select Model select, press ENT to enter the Model Select setting interface.
Model Select
RR
02 x Model 02
03
Model 03
04
Model 04
05'- Model 05
06
Model 06
07 x Model 07
08
Model 08
Press UP or DN to select the model you desired, press ENT to confirm
and marks",/"in the front of selected one. Total 15 models are optiona,
used to save the model data. Press EXT to exit after finished.
DEVO Fi 2E —21

Advertisement

Table of Contents
loading

Table of Contents