Table of Contents
Advertisement
Governor
g
Flight Mode 0
Channel
AUX2
Flight Mode 0
Flight Mode 1
0%
Flight Mode 2
0%
Flight Mode 3
0%
Flight Mode 4
0%
cleention
DEVO F12E
Welcome to use the DEVO F12E transmitter
(2) Automatic setting
(2.1) Automatic Setting:
Under Gyro setting interface, press UP or DN to choose Mode, press R
or L to select Manual setting or Automatic Setting. Choose "Automatic
Setting"
(2.2) Channel:
The default setting is AUX 2. It is possible to alter into other channels
in the interface of Device Output (Refer to "2.10 Device Output").
Gyro Sensor
Flight Mode 0
Mode
Automatic
Channel
AUX2
Switch
ELEV D/R
Flight Mode 0
50.0%
Flight Mode 1
50.0%
Flight Mode 2
50.0%
(2.3) Switch: The switch function isn't available under Automatic setting.
(2.4) Status:
Turn the Flight Mode Switch, the status display present flight mode position.There are "Flight Mode 0","Flight
Mode 1","Flight Mode 2", "Flight Mode 3", "Flight Mode 4" sets. For Flight Mode 3 and Flight Mode 4, Flight
Mode Extra Switch should be activated in Device Select (Refer to "2.9 Device Select").
Display present flight mode position
Gyro Sensor
Flight Mode 0
Mode
Automatic
Channel
AUX2
Switch
ELEV D/R
Flight Mode 0
50.0%
Flight Mode 1
50.0%
Flight Mode 2
50.0%
(2.5) Flight Mode 0:
Press UP or DN to select Flight Mode 0, press R or L can increase or
decrease the value individually. If the gyro used has two modes of NOR
and AVCS, NOR will be activated when the value is less than 50.0%.
In NOR mode, the smaller the value is, the bigger the gyro sensor
sensitivity will be. The factory setting is 50.0%.
(2.6) Flight mode 1, Flight mode 2, Flight mode 3, Flight mode 4 settings
refer to "Flight Mode 0".
After finishing the set, press EXT to exit.
3.10 Governor
Gyro Sensor
g
Flight Mode 0
Mode Automatic
Channel
AUX2
Switch
ELEV D/R
Flight Mode 0
50.0%
Flight Mode 1
50.0%
Flight Mode 2
50.0%
Before setup this function, "Governor" should be set and activated in "Device output' interface. (Refer to 2.10
Device Output)
The control proportion of governor can be separately set in various flight modes. For the absolute revolution
amount, please set in external governor. The amount shown in DEVO F12E governor is just a percentage
for reference. The actual revolution should be read in the external governor.
Press ENT to enter the "Main menu" interface; Press UP or DN to make
the navigation mark to select "Function menu". Press ENT to "Funcation
menu"; Press UPor DN to choose "Governor" then press ENT to enter the
Governor setting interface, which display the options of Status and
channels; Press UP or DN, there are options of "Flight Mode 0", "Flight
Mode 1", "Flight Mode 2", "Flight Mode 3" , "Flight Mode 4" and so on.
(1) Status
Turn the Flight Mode switch", the status display present flight mode position.There are "Flight Mode 0","Flight
Mode 1","Flight Mode 2", "Flight Mode 3", "Flight Mode 4" sets. For Flight Mode 3 and Flight Mode 4, Flight
Mode Extra Switch should be activated in Device Select (Refer to "2.9 Device Select").
DEVO Fl 2E
—71
Advertisement
Table of Contents
