Camber System - devention DEVO F12E User Handbook Manual

Flaperon Mix
g
Offset 0%
Flight Mode Cruise Mode
Flap to Flaperon
Up
Down 0%
Flap to Elevator
Up 0%
Down 0%
cleention
DEVO Fl 2E
Welcome to use the DEVO F12E transmitter
Setting method:
Press ENT to enter Main Menu; Press UP or DN to move the navigation
mark to Function Menu, and press ENT to enter Function Menu. Press
UP or DN to choose Flaperon Mix and Press ENT to enter Flaperon Mix
interface. Picture as right:
(1) Flap Lever Offset setting
This function can be used to set the neutral points of Flaperon servos.
Flaperon Mix
Offset
Flight Mode Cruise Mode
Flap to Flaperon
Up 0%
Down 0%
Flap to Elevator
Up 0%
Down 0%
Press UP or DN to move the Navigation mark to choose "Flap Lever Offset" setting options. Press R or L to
increase or decrease the amount respectively. The adjustable range is ±100%. It is possible to change the
offset direction by changing the plus or minus sign before the amount.
(2) Flight Mode setting
The flight mode should be previously activated in "Device Select" before using this function (Refer to "2.9
Device Select").
Press UP or DN to move the Navigation mark to select "Flight Mode" setting options, press R or L to select
the desired item.
(3) Flap to Flaperon setting
Press UP or DN to move the Navigation mark to choose "UP or Down"
setting options. Press R or L to change the Flaperon Mix value when
moving the Flap stick. The bigger the Value is, the bigger Mix will be. The
adjustable Mix is ranged from -125% to +125%. It is possible to change
the Flaperon Mix direction by changing the plus or minus sign before the
value.
(4) Flap to Elevator setting
Press UP or DN to move the Navigation mark to choose "UP or Down" setting options. Press R or L to change
the Elevator Mix value when moving the Flap stick. The bigger the Value is, the bigger Mix will be. The
adjustable Mix is ranged from -125% to +125%. It is possible to change the Elevator Mix direction by changing
the plus or minus sign before the value.
Press EXT to exit after finishing the setting.
3.7 Camber System
This function can change the Aileron angel, which goes through the central line of the main wings' transect,
and then change the features of main wings.
Camber System
Setting method:
Press ENT to enter Main Menu; Press UP or DN to move the navigation
mark to Function Menu, and press ENT to enter Function Menu. Press
UP or DN to choose Camber System and Press ENT to enter Camber
System interface. Picture as right:
(1) Flap Lever Offset setting
Flight Mode al=
L-Aileron 0%
R-Aileron 0%
L-Flap
0%
R-Flap 0%
L-Tip Aileron
0%
R-Tip Aileron 0%
The flight mode should be previously activated in "Device Select" before using this function (Refer to "2.9
Device Select").
Press UP or DN to move the Navigation mark to select "Flight Mode" setting options, press R or L to select
the desired item.
(2) L-Aileron/ R-Aileron setting
Press UP or DN to move the Navigation mark to choose "L-Aileron or R-Aileron" setting options. Press R or
L to change the position of L-Aileron or R-Aileron with a range of ±100%. It is possible to alter the direction
of L-Aileron or R-Aileron via changing the letter of "R" or "L" before the amount.
DEVO Fl 2E —101