Table of Contents
Advertisement
Digital signa wire
Digs • signa wire
Trainer icon
Training status display: when the
trainer's icon becomes into "X", the
trainee stops flying and the trainer
is working; when the trainer's icon
turns into"V", the trainee is flying
and the trainer is in leisure.
01'—s7 Model 01 0% 00:00
k _;:
Trainee is off and
trainer is working
0 0 0 0 0 0
01'—s7 Model 01 0% 00:00111-;
Trainee is working
and trainer is off
0 0 0 0 0 0
Right Trim
11 /
clXention
DEVO F 1 2 E
Welcome to use the DEVO Fl 2E transmitter
linkage icon
Turn on the power of the trainer's radio. Find out the trainee's model data, and then let the trainer's Radio
bind with the aircraft model and fly it normally. Then turn off the power.lnsert the other end of the digital signal
wire into the trainer's DEVO Fl 2E, and then turn on its power. A linkage icon will be shown as below:
(3) Usage method
The training switch can be freely switchable between left trim and right trim. The default setting is right trim,
see as the right illustration.
During flight, if the trainer pushes Right Trim once, the linkage
icon will be shown as "V" that means the control right is moved
to the trainee from Trainer. If trainer pushes Right Trim once
again, the linkage icon will be shown as "X" that means the
trainer takes back the control right from the trainee.
(4) Setting for training function channels
Trainee is available to get full or part of flight control power to the aircraft model via setting the training function
channel in the trainer's radio. Below is the setting method:
Press the ENT to enter Main Menu, and then press UP or DN to move the navigational mark to select Function
Menu. Then press ENT to enter the Function Menu and press UP or DN to select "Trainer", then press ENT
to enter the Trainer interface. The available channels are shown below, and the current status of trainer switch
is also shown there.
Trainer switch selection:Press UP or DN to select the switch option;
press R or L to select the switch which you want. It includes right and
left trim.The default setting is Right trim.
Channel selection:Press UP or DN to select the channel option; Press
R or
L
to select the channel(s) which you want to grant to trainee. The
channel(s) you have selected will be activated as "Active". The channels
which are not granted to trainee will be kept inhibited. The default setting
is "Inhibit".
Press EXT to exit.
Trainer
g
Switch
Right Trim
Elevator
Inhibit
Aileron
Inhibit
Throttle
Inhibit
Rudder
Inhibit
Gear
Inhibit
Pitch
Inhibit
Gyro
Inhibit
DEVO F 1 2 E — 46
Advertisement
Table of Contents
