Table of Contents
Advertisement
Program Mix 1
2
Warning
All Servos Hold?
Ok
Cancel
Program Mix 1
g
Master
Slave
Position
Exponential
Point
Elevator
Elevator
Pos 0
Off
Point - L
Output
0%
0%
0%
cleention
DEVO Fl 2E
Welcome to use the DEVO F12E transmitter
(2) Setting Method for Curve in Program Mix1
In the Program Mix interface, press UP or DN to select Curve, press ENT to confirm. Then the interface pop
up "All Servos Hold?", press R or L
to choose OK or Cancel. If select
OK, all the servos will be locked in
the current status, if select Cancel,
all servos are unlocked. Press ENT
to setting interface of program Mix1
and it will show the setting item.
Master
.1=1111
Aileron
Throttle
Rudder
Gear
Flap
AUX2
AUX3
(2.1)
Master channel setting
Press UP or DN to move the navigatioal mark to select Master option
and press ENT to Master interface. Press UP or DN to select the desired
channel and press ENT to make a "-ki". Press EXT to be back to Program
Mix 1 interface.
Slave
-
1q
Aileron
Throttle
Rudder
Gear
Flap
Gyro
AUX3
(2.2) Slave channel setting
Press UP or DN to move the navigatioal mark to select Slave option and
press ENT to Slave interface. Press UP or DN to select the desired
channel and press ENT to make a "II". Press EXT to be back to Program
Mix1 interface.
(2.3) Position
There have two options:Pos 0 and Pos 1. Press UP or DN to move the
navigatioal mark to select the "position", press R or L to select "Pos 0"
or "Pos 1" .
Program Mix 1
8 g
Master
Elevator
Slave
Elevator
Position
Pos 0
Exponential
Off
Point
Point - L
Output
0%
0%
0%
(2.4) Exponential Curve
Press UP or DN to choose the setting item of "Exponential" .There are On or Off option when you press the
R or L buttoms. Select On for smooth changes, and Off for changes in the form of fold ling in Exponential
curve, respectively.
Program Mix 1
2
(2.5) Point Setting
Press UP or DN to move the navigation mark of Point option. Press R
or L, there are 7 piont options including "Point-L", "Point-1", "Point-2",
"Point-M", "Point-3", "Point -4" and "Point-H". Select the point you want
to set.
Master
Slave
Position
Exponential
Point
Elevator
Elevator
Pos 0
Off
Output
0%
0%
0%
(2.6) Status setting
(There is no Status options when the piont is Point-L or Point-H) After
selecting the point that you want to set, press UP or DN to move the
navigational mark to Status item. Press R or L, there are two options of
Inhibit and Active. Select Inhibit for unchanging the current amount (the
default setting is Inhibit).
Program Mix 1
8
Master
Elevator
Slave
Elevator
Position
Pos 0
Exponential
Off
Point
Point - 1
Status MIIEEM
Output
0%
0%
0%
DEVO Fl 2E — 79
Advertisement
Table of Contents
