Table of Contents
Advertisement
Switch
\5,
2
Differential
2
Channel
Aileron
Pos 0
0%
Pas 1
0%
Switch
And
© Flight Mode 0
OO
FMOD
1
OO
FMOD 2
© Flight Mode 3
© Flight Mode 4
© Flap Normal
© Flap Midpoint
ciXention
DEVO Fl 2E
Welcome to use the DEVO F12E transmitter
3.7 Differential
If want to use this function, Flaperon, Delta, or 4-Aileron should be previously selected in Wing Type of Model
Menu. Refer to "2.11 Wing Type".
(1) Aileron differential setting
Press ENT to enter Main menu; press UP or DN to choose Function menu. Press ENT to enter Function
menu; press UP or DN to choose Differential, press ENT to enter interface of Differential, illustration as below.
Differential
Mounting servos in left and right ailerons are a must if using this function.
The following interface will be shown after Flaperon, Delta, or 4-Aileron
selected in Wing Type. Refer to "2.11 Wing Type".
(1.1) Channel: Current setting channel is Aileron. System default can
not be set.
(1.2) Setting for Pos 0
Press UP or DN to choose Pos 0, press R or L to increase or decrease
differential value, respectively. The adjustable range is ± 100%.
Channel
Pos 0
0%
Pos 1
0%
Switch
Point 0
(1.3) Setting for Pos 1
Press UP or DN to choose Pos1, press R or L to increase or decrease differential value, respectively. The
adjustable range is ± 100%.
(1.4) Switch selection
It is possible to switch by Setting Switch when differential is in use.
Press UP or DN to choose Switch, press ENT to enter interface of Switch selection, press UP or DN to choose
desired item. Press ENT to confirm,
the desired item whose left side will
be changed into "1" from "0". If two
or more items are selected, the item
And should be selected, whose left
side should be changed into "1" from
"0". Press EXT after finished it.
(2) Rudder differential setting
V-Tail should be previously set in Wing Type of Model Menu if the rudder differential function is activated.
Refer to "2.11 Wing Type". And then the following interface will be shown:
Differential
(2.1) Channel
press UP or DN to move the navigational mark to the item Channel and
press R or L to choose the channel Rudder.
(2.2) Setting for Pos 0
Press UP or DN to choose Pos 0, press R or L to increase or decrease
differential value, respectively, the value with a range of ± 100%.
Channel
Pos 0
0%
Pos 1
0%
Switch
Point 0
(2.3) Setting for Pos 1
Press UP or DN to choose Pos1, press R or L to increase or decrease differential value, respectively, the
value with a range of ± 100%.
(2.4) Switch selection
It is possible to switch by Setting Switch when differential is in use.
Press UP or DN to choose Switch, press ENT to enter interface of Switch selection, press UP or DN to choose
desired item. Press ENT to confirm, the desired item whose left side will be changed into "1" from "0". If two
or more items are selected, the item And should be selected, whose left side should be changed into "1" from
"0". Press EXT after finished it.
DEVO Fl 2E — 68
Advertisement
Table of Contents
