Table of Contents
Advertisement
Program Mix 1
Master
Elevator
Slave
Elevator
Position
Pos 0
Exponential
Off
Point
Point - L
Output
0%
0%
0%
(2.1)
Master channel setting
Press UP or DN to move the navigatioal mark to select Master option
and press ENT to Master interface. Press UP or DN to select the desired
channel and press ENT to make a
".\/".
Press EXT to be back to Program
Mix 1 interface.
Slave
g
up "All Servos Hold?", press R or L
to choose OK or Cancel. If select
OK, all the servos will be locked in
the current status, if select Cancel,
all servos are unlocked. Press ENT
to setting interface of program Mix1
and it will show the setting item.
Aileron
Flaperon
Rudder
Motor
Flap
AUX2
AUX3
Master
Program Mix 1
Warning
All Servos Hold?
Ok
Cancel
cleUention
DEVO F12E
Welcome to use the DEVO F12E transmitter
(2) Setting Method for Curve in Program Mix1
In the Program Mix interface, press UP or DN to select Curve, press ENT to confirm. Then the interface pop
(2.2) Slave channel setting
Press UP or DN to move the navigatioal mark to select Slave option and
press ENT to Slave interface. Press UP or DN to select the desired channel
and press ENT to make a
" 4" .
Press EXT to be back to Program Mix1
interface.
Aileron
Flaperon
Rudder
Motor
Flap
Gyro
AUX3
(2.3) Position
There have two options:Pos 0 and Pos 1. Press UP or DN to move the navigatioal mark to select the "position",
press R or
L
to select "Pos 0" or "Pos 1" .
(2.4) Exponential Curve
Press UP or DN to choose the setting item of "Exponential" .There are
On or Off option when you press the R or L buttoms. Select On for
smooth changes, and Off for changes in the form of fold ling in Exponential
curve, respectively.
Program Mix 1
g
Program Mix
1
Master
Elevator
Slave
Elevator
Position
Pos 0
Exponential =P
Point
Point - L
Output
0%
0%
0%
(2.5) Point Setting
Press UP or DN to move the navigation mark of Point option. Press R
or L, there are 7 piont options including "Point-L", "Point-1", "Point-2",
"Point-M", "Point-3", "Point -4" and "Point-H". Select the point you want
to set.
Program Mix 1
8
Master
Elevator
Slave
Elevator
Position
Pos 0
Exponential
Off
Point
Output
0%
0%
0%
Master
Elevator
Slave
Elevator
Position
Pos 0
Exponential
Off
Point
Point - 1
Status ME=
Output
0%
0%
0%
(2.6) Status setting
(There is no Status options when the piont is Point-L or Point-H) After
selecting the point that you want to set, press UP or DN to move the
navigational mark to Status item. Press R or L, there are two options of
Inhibit and Active. Select Inhibit for unchanging the current amount (the
default setting is Inhibit).
DEVO Fl 2E — 110
Advertisement
Table of Contents
