Monitor; Fail Safe - devention DEVO F12E User Handbook Manual

Program Mix 1
Slave
Position
Exponential
Point
Status
Output
Switch
Elevator
Pos 0
Off
Point - 1
Active
Pos 0
0% 0%
Elevator 0
R-Aileron R 2
L-Aileron R 2
Rudder R 34
Motor -100
Flap 0
AUX2 -100
AUX3 -100
AUX4 -100
AUX5 -100
AUX6 +100
AUX7 +12
cleention
DEVO Fl 2E
Welcome to use the DEVO F12E transmitter
(2.7) output setting
When the Status option is Active, the Output option will be listed.Press
UP or DN to move the navigational mark to Output. Press R or L to
increase or decrease, respectively, the output amount. It is possible to
reverse the mix direction by changing the plus or minus sign before the
amount. The adjustable range is ±100%.
(2.8) Switch Selection
Press UP or DN to select "Switch". Press ENT to enter Switch interface, press UP or DN to choose desired
item. Press ENT to confirm, the desired item whose left side will be changed into "1" from "0". If two or more
items are selected, the item And should be selected, whose left side should be changed into "1" from "0".
Press EXT after finished it.
Program Mix 1 4 g Switch
2
Slave Elevator
0 And
Position
Pos 0
© Cruise Mode
Exponential Off
FMOD 1
Point Point - 1
FMOD 2
Status Active
© Launch Mode
Output 0%
© Land Mode
Switch
0% 0%
OO
ELEV D/R
oO
AILE D/R
3.19 Monitor
This function can display the current status and positions of all the channels' outputs, and check the current
working status of each channel.
Monitor
Press ENT to enter Main Menu, and then press UP or DN to move the
navigational mark to select Function Menu.Press ENT to enter the Function
Menu and then press UP or DN to select servo Monitor and press ENT
to enter the monitor interface for checking the current working status of
each channel. Press EXT to exit .
3.20 Fail safe
There are two possibilities for use if the transmission signal is under abnormal condition. The first one is to
lock the last action data received; the second one is to execute the pre-set data which is pre-set. The default
setting is Servo Hold.
Fail Safe
Elevator Servo Hold
Aileron Servo Hold
Throttle Servo Hold
Rudder Servo Hold
Press UP or DN to select Elevator on the Fail Safe interface, then press
R or L to change the status of Servo Hold into Fail Safe(If you want to
keep Servo hold status, there is no need to re-set). There is a expanded
sub-item blow. Press UP or DN to select 0%, then press R or L to increase
or decrease, respectively, the position amount which centers on the
neutral point of servo. The available value is 125%, respectively. 0% is
the neutral point of servo.
Fail Safe
Elevator
mizm
0%
Aileron Servo Hold
Throttle Servo Hold
Rudder Servo Hold
Setting method:
Press ENT to enter the Main Menu, and then press UP or DN to move
the navigational mark to select Function Menu. Press ENT to enter the
Function Menu then press UP or DN to select Fail Safe and press ENT
to enter the Fail Safe interface.Take the item Elevator as an example
to explain.
DEVO Fl2E — 11 1