Throttle Hold - devention DEVO F12E User Handbook Manual

Dual Rate and Exponential
g
Channel
Position
Dual Rate
Exponential
Normal Mode
Stunt 1
Stunt 2
Pos 0
Elevator
Pos 0
100%
Line
Switch
Switch
Switch
Dual Rate and Exponential
Channel
Position
Dual Rate
Exponential
Normal Mode
Stunt 1
Stunt 2
Pos 0
Elevator
Pos 0
100%
Line
Switch
Switch
Switch
Dual Rate and Exponential
Channel
Position
Dual Rate
Exponential
Normal Mode
Stunt 1
Stunt 2
Pos 0
Elevator
Pos 0
100%
Line
Switch
Switch
clXention
Welcome to use the DEVO F12E transmitter
DEVO F 1 2 E
(2) Position selection
Press UP or DN to move navigation mark to desired item Position.
In the manual mode, the function of Dual rate and Exponential
will be executed by the corresponding D/R switch among PosO
and Pos1. Take the item Elevator at channel as an example.
It's possible to shift between PosO and Pos1 via pushing or
pulling the D/R switch.
(3)
Dual rate adjustment
Press UP or DN to move the navigation mark to desired item Dual Rate,
press R or L to change the number and then the dual rate of the position
will be changed. The factory default setting is 100%.
(4) Exponential
Press UP or DN to select Exponential item of navigation mark. It's possible
to change Dual Rate and Exponential value in Pos when pressing R or
L to change the value. There are ± 100% and Line three adjustment.
(5) Automatic setting
Under working with Flight Mode, it's possible to switch between the Dual Rate and Exponential, which are
set in above"(3) Dual Rate adjustment" and "(4) Exponential adjustment", respectively.
The setttings for Normal Mode, Stunt 1, Stunt 2, Stunt 3, Stunt
4 and Throttle Hold are available. But for Stunt 3 and Stunt
4, Flight Mode Extra Switch at Device Select in Mode Menu
should be activated(Refer to "2.9 Device Select"), and Throttle
Hold in Function Menu should be set as Active(Refer to "3.5
Throttle Hold" below).
(5.1) Normal Flight Mode setting:
Press UP or DN in the navigation mark of Dual rate and Exponential to
select the desired item Normal Flight. Press R or L to set the position
and the Switch. Only the D/R switch control is valid When Switch is
selected, under the Flight Mode, it's possible for Pos to switch the dual
rate and exponential, which are set in above(3) and (4)Exponential
adjustment. The settings for Swtich, PosO, Pos1, Post , Pos3, Pos4 and
Pos5 are valid.
(5.2) The setting for Stuntl, Stunt2, Stunt3, Stunt4 and Throttle Hold can be set up according to above Normal
Flight Setting.
Press EXT to exit after finishing the setting.
3.5 Throttle Hold
If this function is set, the switch will be exectuted by hold switch. The setting value of throttle hold is ranged
from -20.0-50.0%. the default setting is Inhibit.
DEVO F 2 E — 32