Balance - devention DEVO F12E User Handbook Manual

Differential
2
Channel Flap
Pos 0 0%
Pos 1 0%
Switch
Point 0
Differential
Channel
Pos 0
Pos 1
Switch
Switch
And
© Flight Mode 0
OO
FMOD 1
OO
FMOD 2
© Flight Mode 3
© Flight Mode 4
© Flap Normal
© Flap Midpoint
Flap
0%
0%
Point 0
Balance
8
2
Channel Aileron
Point < Right Active
0%
Point - Right Active
0%
Point - 1 Inhibit
cleention
DEVO Fl 2E
Welcome to use the DEVO F12E transmitter
Differential
Channel Rudder
Pos 0
0%
Pos 1 0%
Switch
Point 0
Switch
0 And
© Flight Mode 0
FMOD 1
FMOD 2
© Flight Mode 3
© Flight Mode 4
© Flap Normal
© Flap Midpoint
(3)
Flap differential setting
It should be previously set the flap dual channel function in Wing Type of Model Menu (refer to "2.11 Wing
Type") in order to activate the menu of Flap Differential.
(3.1) Channel
press UP or DN to move the navigational mark to the item Channel and
press R or L to choose the channel Flap.
(3.2) Setting for Pos 0
Press UP or DN to choose Pos 0, press R or L to increase or decrease
differential value, respectively. The adjustable range is ± 100%.
(3.3) Setting for Pos 1
Press UP or DN to choose Post, press R or L to increase or decrease differential value, respectively. The
adjustable range is ± 100%.
(3.4) Switch selection
It is possible to switch by Setting Switch when differential is in use.
Press UP or DN to choose Switch, press ENT to enter interface of Switch selection, press UP or DN to choose
desired item. Press ENT to confirm,
the desired item whose left side will
be changed into "1" from "0". If two
or more items are selected, the item
And should be selected, whose left
side should be changed into "1" from
"0". Press EXT after finished it.
3.8 Balance
This function can adjust the parame ers of the two servos which are used in the dual channels. It should be
previously activated one of these wing types of Flaperon, Delta, 4-Aileron, and V-Tail in Wing Type at Model
Menu. Refer to "2.11 Wing Type".
Balance
Press ENT to enter Main Menu, press UP or DN to choose Function.
Press ENT to enter Function menu, press UP or DN to choose Balance.
Press ENT to enter interface of Balance setting, picture as right:
(1) Channel: current setting channel is Aileron. System default can not
be set.
(2) Point parameter adjustment
Point< Right Setting: Press UP or DN to choose "Point< Right". If need
to adjust the value, press L (0% means no adjusting). A minus value
means the amending direction is downward; press R to adjust value(0%
means no adjusting). A plus value means the amending direction is
upward. The adjustable range is ± 100%.
DEVO Fl 2E —69
Channel Aileron
Point < Right Active
0%
Point - Right Active
0%
Point - 1 Inhibit