Pitch Curve - devention DEVO F12E User Handbook Manual

Pitch Curve
Warning
All Servos Hold?
Ok Cancel
Pitch Curve
Channel
Position
Exponential
Point
Output
Throttle Stick
AUX2
Pos 0
Off
Point - L
-100%
Inhibit
-100% -100%
Pitch Curve
Channel
Position
Exponential
Point
Output
Throttle Stick
AUX2
Pos 0
Off
MME16
-100%
Inhibit
-100% -100%
Pitch Curve
Channel
Position
Exponential
Point
Stutus
Output
Throttle Stick
AUX2
Pos 0
Off
Point - 1
Active
-67%
Inhibit
-100% -100%
Pitch Curve
2
Channel
Position
Exponential
Point
Stutus
Output
Throttle Stick
AUX2
Pos 0
Off
Point - 1
Active
-67%
Inhibit
-100% -100%
d
eUention
Welcome to use the DEVO F12E transmitter
DEVO Fl 2E
3.16 Pitch Curve
Pitch Curve can be adjusted via seven points. Pitch Curves of Pos 0 and Pos 1 can be set, respectively.
The item Pitch should be previously set in Device Output at Model Menu (Refer to "2.10 Device Output").
Setting method:
Press ENT to enter Main Menu, Press UP or DN to move navigation mark to select Function Menu. Press ENT
to enter Function Menu. Press UP or DN to select Pitch Curve, Press ENT to enter Pitch Curve interface. A
dropdown menu with "All Servos
Hold?" will pop up. select Ok for
locking all the current statuses of
servos, and select Cancel for
unlocking the current statuses. And
the interface will show the current
used channel and the current
position statuses of switches.
(1) Channel: this item will show that the channel Pitch has been set.
(2) Position selection
Press UP or DN in the "Pitch Curve" setting interface to select "Position", press R or L to select the item you
want to set in the list with Pos 0 and Pos 1.
(3) Exponential setting
Pitch Curve
g
Channel AUX2
Press UP or DN in the "Pitch Curve" setting interface to select "Exponential"
setting, press R or L and there are two options: Off and On. If you want
Position
Exponential
Pos 0
to make the curve have a smooth change, choose On; if not, choose Off.
Point Point - L
(4) Curve setting
Output -100%
Throttle Stick Inhibit
Including "Point" and "Output ".
-100% -100%
(4.1)
Point setting
Press UP or DN in Pitch Curve interface to select Points setting. Press
R to expand a list including seven points: "Point-L", "Point-1", "Point-2",
"Point-M", "Point-3", "Point-4" and "Point-H". Press R or L to select the
point you want to adjust.
(4.2) Status setting
Press UP or DN to move navigation mark to Status and press R or L to
choose Inhibit or Active. Select Inhibit if keeping the current value(the
default setting is Inhibit). Select Active for changing the above points'
value.
Note: After select point -L or Point-H, the status setting won't be display.
(4.3) Output setting
There is a expand item "Output" after select Status Active, press UP or
DN to select Output setting, press R or L to increase or decrease,
respectively, the output value. The adjustable range is ±100%.
DEVO Fl 2E — 76