Table of Contents
Advertisement
ThrottIP CilrUP
1E1
Point
I .a
Point - L
Point
Status
Inhibit
1
Throttle Curve
Point - 1
Th roll! e-
u rcif:!
Nib< to ThrnttIP
Eleiyiator
Down
ociXention
DEVO 7E
Welcome to use the DEVO 7E transmitter
(3.1) Adjustment for Point
Press UP or DN in Throttle Curve interface to move the navigation mark to desired item Point. Press R, an
expansion list including "-L" "-1", "-2", "-M", "-3", "-4" and "-H" seven points is shown and can be selected via
pressing R or L.
(3.2) Status adjustment
Press UP or DN to move navigation mark to Status and press R or L to choose Inhibit or Activate. Click Inhibit
if you don't amend the amount of the selected point. The factory default is Inhibit. Click activate if you want
to amend the amount of the selected point.
(3.3) Output adjustment
An expansion list of Output items will be shown after activating the Status.Press UP or DN to move navigation
mark to select Output item. And press R or L to increase or decrease the amount of selected point with a
minimum of 0.0% and a maximum of 100.0%.
(3.2) Status adjustment
Press EXT to exit after finished.
3.7 Mix to throttle
Ti
P I:: Li ryR
St;=itu!::;
Active
Status
50, 0%
0
.n n.0
L I HU H
(3.3) Output adjustment
The Mix to Throttle function is designed to permit the main rotor speed to remain constant despite a change
in load when operating the aileron, elevator or rudder. Generally, it is not advised to use this function except
when stunt flying.
Setup:
Press ENT to enter Main menu in the main interface. Press UP or DN to move navigation mark to select
Function Menu. Press ENT to enter function menu. Press UP or DN to select Mix to Throttle. And press ENT
to enter Mix to throttle interface as in below illustration.
There are three settings: elevator, aileron and rudder. If the
item of Channel is shown as Elevator, there are UP, DOWN
and Switch in the interface. If the item of Channel is Aileron
or Rudder, the contents in the said interface will be changed
into Left, Right and Switch. Take the example of Channel
set as Elevator to illustrate the setting method.
(1) Up setting
In the Mix to throttle interface, press UP or DN to move the navigation mark to select UP item. Press R or L
to increase or decrease the mix amount when moving the throttle stick upwards. A positive MIX value means
that as ELEV channel output value is increased (when flying forward), the THRO value will also be increased
automatically.A negative MIX value means that as ELEV channel output value is increased (when flying
forward), the THRO value will be decreased automatically. The available range of adjustment is ±125% .
DEVO 7E —
28
Advertisement
Table of Contents
