Table of Contents
Advertisement
Slave
Aileron
Throttle
Rudder
Gear
Pitch
Gyro
AUX3
Program Mix 1
2
Elevator
Master
Slave
Elevator
Exponential
Off
Point
Point -
L
Program Mix 1
g
Warning
All Servos Hold?
Ok
Cancel
Output
0%
Switch
On
0%
0%
ciXention
DEVO Fl 2E
Welcome to use the DEVO F12E transmitter
(2) Slave channel setting
Press UP or DN to move the navigatioal mark to select Slave option and
press ENT to Slave interface. Press UP or DN to select the desired
channel and press ENT to make a "4". Press EXT to be back to Program
Mix1 interface.
(1.3) Gain setting: Take Elevator at Master as an example.
Program Mix 1
Master
Elevator
Slave
Elevator
Up El
Down
0%
Offset
0%
Switch
On
(1.3.1) UP:
Mix amount setting when elevator stick moved upward.
Press UP or DN to move the navigational mark to select Up to item. Press
R or L to increase or decrease, separately, the mix amount. It is possible
to reverse mix direction through changing the plus or minus sign before
amount. The adjustable range is ±125%.
(1.3.2) Down:
Mix amount setting when elevator stick moved backward. Press UP or DN to move the navigational mark to
select Down item.Press R or L to increase or decrease, separately, the mix amount. It is possible to reverse
mix direction through changing the plus or minus sign before amount. The adjustable range is ±125%.
(1.3.3) Offset Setting
This function can make Slave begin to mix through the corresponding Lever switch from a certain point as
the starting point.
Press UP or DN select the "Offset"setting, Press R to increase the mix amount and press L to decrease. It
is possible to reverse Offset direction by pressing R or L button to change the plus or minus sign before
amount. The adjustable range is ±100%.
(1.4) Switch Selection
Press UP or DN to choose the
navigation mark of Switch setting item
and press ENT to enter the select
interface of Switch. It is chosen if the
Switch item is marked with
"4 ".
After
finished, press EXT to return to the
Program Mix to make other settings
or press EXT once again to exit.
Program Mix 1
2
Switch
2
Master
Slave
Up
Down
Offset
Switch
Elevator
Elevator
0%
0%
0%
V
Always On
Normal Mode
Stunt 1
Stunt 2
Stunt 3
Stunt 4
Throttle Hold
ELEV D/R
(2) Setting Method for Curve in Program Mix1
Press UP or DN to select Curve, press ENT to confirm. Then the interface pop up "All Servos Hold?", press
R or L to choose OK or Cancel. If
select OK, all the servos will be
locked in the current status, if select
Cancel, all servos are unlocked.
Press ENT to setting interface of
program Mix1.
Master
111=151M.
Aileron
Throttle
Rudder
Gear
Pitch
AUX2
AUX3
(2.1) Master channel setting
Press UP or DN to move the navigatioal mark to select Master option
and press ENT to Master interface. Press UP or DN to select the desired
channel and press ENT to make a "-\/". Press EXT to be back to Program
Mix 1 interface.
DEVO Fi 2E —
42
Advertisement
Table of Contents
