Table of Contents
Advertisement
cle()ention
DEVO F12E
Welcome to use the DEVO F12E transmitter
(2) Fixed ID cancellation
Insert the assorted BIND PLUG into the output terminal of BATT
before the receiver is powered on, and then plug 5V DC power into
other output terminal. The red light of receiver will flash slowly. This
means the fixed ID code has been cancelled. Pull out bind plug.
DEVO F12E also needs to make relative cancellation and revision
after the fixed ID in receiver is cleared out.
In the main interface press the ENT to enter Model Menu and then press
UP or DN to move the navigational mark to select Model Menu. Press
ENT to enter ModeL Menu. Press UP or DN to select Fixed ID code and
press ENT to enter the Fixed ID code interface.Press UP or DN to select
Status option, Press R or L to change the status to Off. Then press EXT
to exit.
Fixed ID
2
Status
11.0 Installation requirement for receiver
(1) It is important to correctly mount your radio system in your model. Below are some advices on how to
install your equipments.
(2) Wrap the receiver with 10mm thickness polyfoam and fix it with a rubber band or magic string on your
helicopter or airplane. It helps protect the receiver.
(3) It is necessary for you to use rubber grommets and copper sleeves to isolate the vibration from the main
body. The mounting screws cannot be over-tightened. Otherwise, the rubber grommets will be distorted
and decrease the vibration absorption effect.
(4) When mounting the servos, make sure the servos' bell cranks can move freely over their whole travel
range and ensure the control linkages don't touch or impede the movement of the servos.
(5) If installing various switches,please keep them far away from the engine tuned pipe and high vibration
sources. Ensure all the switches move freely over their whole range.
(6) Don't make the receiver antennas wrapped or parallel,keep the two antennas form 90 degrees angle.
11.1 Receiver Frame rate setting
There are 11Millisecond and 22 Millisecond Frame Rate. When using 11 Millisecond frame rate, it can't be
compatible with Analog servos. Please select the 22 Millisecond Frame Rate if use Anolog servos.
(1) LED Indicator
Red LED indicates 22ms frame rate;
Blue LED indicates 11ms frame rate;
Red&Blue LED indicate the frame rate is under setting;
Red& Blue LED flash means both frame rate can be set;
DEVO F1 2E —15
Advertisement
Table of Contents
