Fail Safe; Sensor View - devention DEVO F12E User Handbook Manual

ciXention
DEVO Fl 2 E
Welcome to use the DEVO F12E transmitter
3.16 Fail safe
There are two possibilities for use if the transmission signal is under abnormal condition. The first one is to
lock the last action data received; the second one is to execute the pre-set data which is pre-set. The default
setting is Servo Hold.
Fail Safe
2
Setting method:
Press ENT to enter the Main Menu, and then press UP or DN to move
the navigational mark to select Function Menu. Press ENT to enter the
Function Menu then press UP or DN to select Fail Safe and press ENT
to enter the Fail Safe interface.Take the item Elevator as an example to
explain.
Elevator Servo Hold
Aileron Servo Hold
Throttle Servo Hold
Rudder Servo Hold
Press UP or DN to select Elevator on the Fail Safe interface, then press R or L to change the status of Servo
Hold into Fail Safe(If you want to keep Servo hold status, there is no need to re-set). There is a expanded
sub-item blow. Press UP or DN to select 0%, then press R or L to increase or decrease, respectively, the
position amount which centers on the neutral point of servo. The available value is 125%, respectively. 0%
is the neutral point of servo.
Fail Safe
Elevator
—11
0%
Aileron
Servo Hold
Throttle Servo Hold
Rudder Servo Hold
The setting methods for other channels are same as above.
Press EXT to exit after finished.
Note: checking whether all the actions when fail safe happened are
correct, is a must after the setting is finished. It is dangerous to use full
throttle, especially after fail safe taken place.
3.17 Sensor View
Setting method:Press ENT to enter the Main Menu and press UP or DN to move the navigational mark to
select Function Menu.Then press ENT to enter the Function Menu and press UP or DN to select Sensor
View, then press ENT to enter the Sensor View interface, like below pictures. If all the sensors disconnect,
telemetry signal lost, there will be inhibits shown on the view. If all work normal, all the measured data will
be shown.
Sensor View
8 g
Sensor View
.1}
Voltage Temperature
00:00 Inhibit Inhibit
Inhibit Inhibit
Inhibit Inhibit
Inhibit Inhibit
Inhibit Inhibit
Inhibit
Rate Sensor GPS Sensor
=
_
Inhibit Inhibit
a
Inhibit Inhibit
Inhibit Inhibit
DEVO F I 2E —44