devention DEVO F12E User Handbook Manual page 62

ciXention
DEVO Fl 2E
Welcome to use the DEVO F12E transmitter
(2.1) Receiver VO(Internal) PFV(Power Feeding Voltage) Alarmed value can be setted as 3.6
-
6V
Voltage Voltage
Internal: VO Internal: VO Active
3.6V
External: V1 Inhibit External: V1 Inhibit
External: V2 Inhibit External: V2 Inhibit
Voltage setting: press R or L to
activate the VO, the alarm interface
will appear in the interface , please
refer to the Illustration.
Press UP or DN to select the Alarm
Voltage setting, press R or L to set
the value. The range is 3.6-6V. you
can continue to set other items after
you finished.
(2.2) External:V1
Press UP or DN enter to Extemal:V1
setting interface. Press R or L to
activate the V1, the details refers to
the Illustration.
Press UP or DN to select the Alarm
Voltage setting. Press R or L to set
the value. The setting range is 0.
2-99.9V. you can continue to set
other items after you finished.
Voltage Voltage
Internal: VO Inhibit
External: V1
External: V2 Inhibit
Internal: VO Inhibit
External: V1
112=1
0.2 V
External: V2 Inhibit
(2.3) External: V2 setting can refer to External V1 setting.
Press EXT back to sensor setting interface after you finished.
(3) Temperature sensor
The temperature sensor can measure up to 4 different temperature(i.e.motors).You can choose Celsius or
Fahrenheit.The alarmed value can be setted to 4 different temperature.Once the measured value is higher
than the setting value, the radio will alarm.The Alarm Temperature value can be setted as -20-220'C or
-4.0-428.0° F.
Temperature Setting:
In the "Sensor Setting"interface, press UP or DN to make the navigation
mark to choose "Temperature Sensor", and press ENT to enter 'Temperature
Sensor"setting interface. See the illustration.
(3.1) Unit
Press UP or DN to make the navigation mark to choose "Unit"setting item,
and press R or L to choose Unit, two kinds of Unit:Celsius and Fahrenheit.
Temperature
Unit Celsius
Temp. T1 Inhibit
Temp. T2 Inhibit
Temp. T3
Inhibit
(3.2) Alarm Temperature settings
Press UP or DN select the T1, Press R or L to Active the setting. Inhibit will change to Active and Alarm
temperature will be shown. If you choose Inhibit, the Alarm temperature value won't be shown.
Press UP or DN to select "Alarm"setting, press R or L to set the alarm
temperature value. Press UP or DN to set other items after finishing
the setting.
(3.3) T2, T3, T4 setting
Refer to the step of "(3.2)T1".
Temperature
Unit Celsius
Temp. T1
Active
100°C
Temp. T2 Inhibit
Temp. T3
Inhibit
(4) GPS setting
There are 4 items including Altitude Type,Speed Unit, Date Type and Time Zone in the GPS receiver setting
interface.
DEVO F I 2E — 62