Sensor Setting - devention DEVO F12E User Handbook Manual

Fixed ID Fixed ID
Status
ID Code 129965
Status
ID Code
On
29965
(Fig. 2)
(Fig. 3)
cleention
DEVO F12E
Welcome to use the DEVO F12E transmitter
Fixed ID
Status
(Fig. 1)
Press ENT key after the new ID has been setted. An inquiry interface of 'Are you sure?" pop up. "ID Code
Matching ... ..." will be shown after press ENT. After matching, the interface will be returned to Model Menu.
Fixed ID Fixed ID
Fixed ID
ID Match
(2) Fixed ID cancellation
Insert the assorted BIND PLUG into the output terminal of BATT before the
receiver is powered on, and then plug 5V DC power into other output terminal.
The red light of receiver will flash slowly. This means the fixed ID code has
been cancelled. Pull out bind plug. DEVO F12E also needs to make relative
cancellation and revision after the fixed ID in receiver is cleared out.
Fixed ID
g
Status
In the main interface press the ENT to enter Model Menu and then press
UP or DN to move the navigational mark to select Model Menu. Press
ENT to enter ModeL Menu. Press UP or DN to select Fixed ID code and
press ENT to enter the Fixed ID code interface.Press UP or DN to select
Status option, Press R or L to change the status to Off. Then press EXT
to exit.
2.14 Sensor setting
Setting method: press ENT enter to the Main Menu. Press UP or DN to select the Model Menu. Press ENT
enter to Model Menu. Press UP or DN to select sensor press ENT enter to the sensor setting interface. See
the Illustration.
Sensor Setting Press R or L to select Activate or Inhibit (the default setting is Inhibit),
such as press Activate will includes No Signal Warning,Voltage sensor,
Temperature sensor,GPS receiver setting etc.
(1) No Signal
Press UP or DN to make the navigation mark to choose "No Signal ".
Press R or L to choose " Inhibit" or "Active"(default setting is" inhibit").
If you choose "Active", the Radio will alarm when telemetry signal lost.
Picture as left:
Status
No Signal Inhibit
Sensor Submenu
Voltage
Temperature
GPS Setting
2) Voltage setting
There are 3 different types of voltage can be measured.lt includes Interna:VO, External:V1 and V2 which can
be monitored two different external voltage(i.e. battery) respectively.Once the measured voltage is lower than
the setting value, the Radio will alarm.
DEVO Fl 2E —61