Throttle Curve - devention DEVO F12E User Handbook Manual

(DI
Hold Status
Throttle Hold... RUDD D/R
Display of switch status
Hold Position
0.0%
Throttle Curve
Warning
All Servos Hold?
Ok Cancel
Throttle Curve
Channel Throttle
Position Pos 0
Exponential Off
Point
Point - L
Output
0.0%
Throttle Stick
Inhibit
0.0% 0.0%
ciXention
DEVO F 1 2 E
Welcome to use the DEVO F12E transmitter
Setting method:
Press ENT to enter Main Menu, Press UP or DN to move navigation mark to select Function Menu. Press
ENT to enter Function Menu. Press UP or DN to select Throttle Hold, Press ENT to enter Throttle Hold
interface, as below illustration:
Press R or L to activate Throttle Hold
function, and expansion list will be
shown as Hold status, Throttle Hold
Switch, Hold Position.
Throttle Hold
2
Throttle Hold
Hold Status M .
Off
Hold Status
1
Throttle Hold... RUDD D/R
Hold Position 0.0%
(1) There are two items under Throttle Hold Status: Active and Inhibit. The factory default setting is Inhibit.
(2) Throttle Hold Switch setting
It's invalid for setting, the factory default is RUDD D/R which will be shown in the status item. When the Throttle
Hold switch is on, data under the Throttle Hold can not be amended until Throttle Hold switch to be off, and
the hold status is changed.
Throttle Hold
(3) Hold Position
In the Throttle Hold interface, press UP or DN to make the Navigation mark to choose "Hold Position" setting
options. Press R or L to change data, the minimum value is -20.0%; the maximum value is +50.0%.
Press EXT to exit after finishing the setting.
3.6 Throttle Curve
Throttle Curve are adjusted through 7 points.
Press ENT to enter main menu, Press UP or DN to move navigation mark to select Function Menu. Press
ENT to enter Function Menu. Press UP
or DN to select Throttle Curve, Press
ENT to enter Throttle Curve interface.
The enquiry dropdown is shown"All
servos hold?" If select OK, all the servos
will be locked at the current status, if
click Cancel, all the servos will be
unlocked at the current status.
(1) Channel setting
The default setting is Throttle Channel, and can not reset.
(2) Position selection
Press UP or DN in the "Throttle Curve" setting interface to select "Position", press R or L to select the item
you want to set in the list with Pos 0 and Pos 1.
DEVO F 1 2 E — 66