Trainer - devention DEVO F12E User Handbook Manual

Digs • sign wire
Digital signal wire
01 1 "‹. Model 01 00:00
Linkage icon at
trainee's DEVO F12E
0 0 0 0 0 0
Right Trim
cleention
DEVO Fl 2E
Welcome to use the DEVO F12E transmitter
3.22 Trainer
Two DEVO F12E transmitters working together can execute the training function to meet the requirements
for the beginner. The setting method is shown as below:
(1) Data copy
First, use the wireless copy function between two DEVO F12E to copy the main transmitter's model data to
the trainee's transmitter, this promise the model data between two transmitters is same. Refer the copy
method to the second part of helicopter "2.4 model wireless copy" and do the following steps:
(2) Linkage
Insert the digital signal wire from the trainer's transmitter into the DSC
socket of the trainee's transmitter. Turn on the transmitter and a linkage
icon will be shown on the boot screen.
linkage icon
Turn on the power of the trainer's radio. Find out the trainee's model
data, and then let the trainer's Radio bind with the aircraft model and
fly it normally. Then tum off the power.lnsert the other end of the digital
signal wire into the trainer's DEVO F12E, and then turn on its power.
A linkage icon will be shown as below:
Trainer icon
Training status display: when the
trainer's icon becomes into "X", the
trainee stops flying and the trainer
is working; when the trainer's icon
turns into",/", the trainee is flying
and the trainer is in leisure.
(3) Usage method
The training switch can be freely switchable between left trim and right trim. The default setting is right trim
see as the right illustration.
During flight, if the trainer pushes Right Trim once, the linkage icon
will be shown as "V" that means the control right is moved to the
trainee from Trainer. If trainer pushes Right Trim once again, the
linkage icon will be shown as "X" that means the trainer takes back
the control right from the trainee.
(4) Setting for training function channels
Trainee is available to get full or part of flight control power to the aircraft model via setting the training function
channel in the trainer's radio. Below is the setting method:
01 14‹. Model 01 00:00
Trainee is off and
trainer is working
0 0 0 0 0 0
01 1 ..< Model 01 00:00111Fa
g
Trainee is working
1
and trainer is off
0 0 0 0 0 0
Press the ENT to enter Main Menu, and then press UP or DN to move
the navigational mark to select Function Menu. Then press ENT to enter
the Function Menu and press UP or DN to select "Trainer", then press
ENT to enter the Trainer interface. The available channels are shown
as left illustration, and the current status of trainer switch is also shown
there.
Trainer
Switch
Right Trim
Elevator Inhibit
R-Aileron Inhibit
L-Aileron Inhibit
Rudder
Inhibit
Motor Inhibit
Flap Inhibit
AUX2 Inhibit
DEVO Fl 2E — 113