Table of Contents
Advertisement
cleention
DEVO Fl 2E
Welcome to use the DEVO F12E transmitter
(1) Elevator Stick setting
This function is that: if the elevator stick position is set at one point, this point will become the cut-off point
whether to mix. when the elevator stick is moved down from this point, the mix will be cancelled; While the
elevator stick is moved up from this point, the mix will be activated.
Press UP or DN to move the Navigation mark to select "Elevator Stick" setting options, press R or L to increase
or decrease, respectively, the value with a range of 01%-100%. When the elevator stick is moved down from
the set value, the mix will be cancelled; while the elevator stick up from this value, the mix will be activated.
The default setting is Inhibit.
(2) Rudder Stick setting
The setting is same as above. The adjustable rang is from UR1% to UR100%, and the factory setting is Inhibit.
(3) Mix value setting for each flight mode
There are total five flight modes. The flight mode should be previously set at Device Select in Mode Menu
(Refer to "2.9 Device Select").
Press UP or DN to move the Navigation mark to select the desired flight
mode of "Left" setting options. Press R or L to change Rudder mix value
when moving the aileron stick leftward. It is possible to change the mix
direction via changing the plus or minus sign before the value. The
adjustable mix is ±125%.
Press UP or DN to move the Navigation mark to select the desired flight
mode of "Right" setting options. Press R or L to change Rudder mix
valuer when moving the aileron stick rightward. It is possible to change
the mix direction via changing the plus or minus sign before the value.
The adjustable mix is ±125%. After finishing the set, press EXT to exit.
Aileron to Rudder Mix
Land Mode
Elevator Stick
Inhibit
Rudder Stick
Inhibit
Cruise Mode
Left
Right
0.0%
3.13 Elevator to Flap Mix
This function aims at mixing flap when operating elevator stick. It can be respectively set in each flight mode,
which should be previously set at Device Select in Mode Menu (Refer to "2.9 Device Select").
Setting method:
Press ENT to enter Main Menu; Press UP or DN to move the navigation
mark to Function Menu, and press ENT to enter Function Menu. Press
UP or DN to choose Elevator to Flap Mix and Press ENT to enter Elevator
to Flap Mix interface. Picture as right:
(1) Cruise Mode
(1.1) UP setting
Elevator to Flap Mix
8
g
Cruise Mode
Up
Down
Offset
Speed Mode
Up
Down
Offset
0%
0%
0%
0%
0%
Press UP or DN to move the Navigation mark to select "UP" setting options in the Cruise Mode. Press R or
L to change Flap mix value when moving the Elevator stick upward. It is possible to change the mix direction
via changing the plus or minus sign before the value. The adjustable mix is ±125%.
(1.2) Down setting
Press UP or DN to move the Navigation mark to select "Down" setting options in the Cruise Mode. Press R
or L to change Flap mix value when moving the Elevator stick downward. It is possible to change the mix
direction via changing the plus or minus sign before the value. The adjustable mix is ±125%.
(1.3) Offset setting
Press UP or DN to move the Navigation mark to select "Offset" setting options in the Cruise Mode. Press R
or L to amend the central point of flap servo. The bigger the value is, the bigger the offset will be. It is possible
to change the offset direction via changing the plus or minus sign before the value. The adjustable offset
range is ±100%.
(2) "Speed Mode", "Thermal Mode", "Launch Mode", "Land Mode" 4 settings refer to "(1) Cruise Mode".
After finishing the set, press EXT to exit.
DEVO Fl 2E — 105
Advertisement
Table of Contents
