Table of Contents
Advertisement
Throttle Hold
Hold :El
5
it c h
H LL :1
01
TI-IrottIP
Lir? e
!ET
All 3 e
r%"1:- . 1
o I d ?
Throtti e C ij r'...'e
Expo ri e al
Off
L
Flight tylode
Normal ...
Welcome to use the DEVO 7E transmitter
deention
DEVO 7E
Throttle Hold
HO
id St atu!=;
RN
I'll
ETP
Throttle Hold
Hold Slat
IEEE
P
ri F.:
I
Press R or L to activate Throttle Hold function, and expansion list will be shown as Throttle hold status, Throttle
hold position and Throttle hold switch.
(1) There are two items under Throttle Hold Status: Active and Inhibit. The factory default setting is Inhibit.
(2) Throttle Hold position
In the Throttle Hold interface, press UP or DN to make the Navigation mark to choose "Throttle Hold Position"
setting options. Press R or L to change data, the minimum value is -20.0%; the maximum value is +50.0%.
(3) Throttle Switch setting
It's invalid for setting, the factory default is HOLD switch
which will be shown in the status item. When the Throttle
Hold switch is ON, data under the Throttle Hold can not be
amended until Throttle Hold switch to be OFF, and the hold
status is changed.
Press EXT to exit after setting up finished.
3.6 Throttle Curve
Throttle curve are adjusted through seven points, which of all the flight modes can be respectively set. The
flight mode include Normal Flight, Stunt.
Press ENT to enter main menu, Press UP or DN to move navigation mark to select Function Menu. Press
ENT to enter Function Menu. Press UP or DN to select Throttle Curve, Press ENT to enter Throttle Curve
interface.The enquiry dropdown is shown"All servos hold?" If click OK, all the servos will be locked at the
current status, if click Cancel, all the servos will be unlocked at the current status.
(1) Flight Mode
There are total two flight modes: Normal Flight, Stunt. The Curve of which can be respectively set in their
corresponding flight mode. The setting method is to press UP or DN to select Flight Mode in Throttle Curve
interface. The corresponding flight mode will be shown when the Flight Mode switch shifts via pushing or
pulling the Flight Mode Switch. And the exponential can be adjusted after Flight Mode is selected.
(2) Exponential Adjustment
Press UP or DN in Throttle Curve interface to move
navigation mark of exponential curve and press R or L
to set the exponential function Off and On. The throttle
curve will be changed smoothly if touching ON, or in fold
line if clicking OFF.
(3) Curve setting
It includes two items: Point and Output.
Throttle
u ryiP
49. 1 1. 1
Flight Mode
II
• 11
.
1%.10ririal
Expo e
It
al
I 121113 LI El
DEVO 7E-
27
Advertisement
Table of Contents
