Table of Contents
Advertisement
Tri rn :3.:ferri
Rudder
Throttle
4/20
Tri
iyiste in
E e
I
No rrri al
Aileron
Position :3
it c:
up .
7,51a
C :
hannel
is
Welcome to use the DEVO 7E transmitter
cle(Lnlion
DEVO 7E
2.6 Type Select
This transmitter offers a choice of two model types. The
Type Select
1E1
options are helicopter and airplane.
Press ENT to Main Menu, press UP or DN to select Model
Menu. Press ENT to enter and press UP or DN to select
Type Select and press ENT to enter Type select interface.
Use UP or DN to select Helicopter or Airplane, press ENT
to confirm, then press EXT to exit.
2.7 Trim System
The Trim System permits the user to fine tune the following items: Elevator, Aileron, Rudder, Throttle. The trim
step is divided in to 20 (factory default is 4). Using small values, permits fine trim control, larger values make
larger adjustments for each 'click' of trim. the procedure to adjust the trim step is as follows:
Press ENT to get Main Menu and press UP or DN to select Model Menu. Press ENT to enter and press UP
or DN to select Trim System, press ENT to enter setting interface. Use UP or DN to select Elevator,Aileron,Rudder
and Throttle. Use R or L to change the step value.Press ENT to confirm and EXT to exit.
Tri rn i~i s.iste
Elevator
.
.111--!
19 1
4/
2
0
Press UP or DN to select the trim which will set, press R to increase the trim value and press L to decrease.
For elevator, aileron and rudder, there are two more options : Normal and Limited. Press R or L you can
change the setup. " Normal: means the trim is always working although th corresponding stick stays anywhere.
"Limited" means the trim is out of working when the corresponding stick is at maximum position.
The last 3 settings in this menu determine if the trim is applied at full control stick or not. This can prevent
servo binding at maximum extents. When "NORM" is displayed, the trim setting is always applied, even at
100% travel. "LIMIT" setting, means that the trim is not applied when the control stick is a full travel. Default
is "NORM". Press ENT to confirm, EXT to exit.
Press EXT to exit after finished.
2.8 Stick Position Switch
According to the following setting, the switch can be used as a switch. The turn-on or turn-off position at which
stick stays can also be settable.
Setup:
Press the ENT to get Main Menu and press UP or DN to select Model Menu. Press ENT to get Model Menu
and press UP or DN to select Stick Position Switch, press ENT to get Stick Position Switch setting interface.
There are four options under the Stick postion switch: SPSO,
SPS1,SPS2,SPS3. Press R or L to choose the switch you
want to define.
DEVO 7E—
1 9
Advertisement
Table of Contents
