Table of Contents
Advertisement
Welcome to use the DEVO 7E transmitter
cleUention
DEVO 7E
11.0 Installation requirement for receiver
Below is some advice on how to install your equipment.
(1) Using 10mm thick foam, wrap the receiver and attach it securely to the aircraft using a cable tie or strong
rubber band. The foam will help protect the receiver.
(2) It is suggested to use rubber grommets and copper washers to isolate the receiver from vibrations. Do not
over tighten the screws in order that the grommets are not damaged otherwise vibration absorption will be
reduced.
(3) When mounting the servos, make sure the servos' bellcranks can move freely over their whole travel range
and ensure the control linkages don't touch or impede the movement of the servos.
(4) If installing additional switches, please install them far away from the engine exhaust pipe and other high
vibration sources. Ensure all the switches move freely over their entire range.
(5) Don't wrap the receiver antennas together or make them parallel; horizontal at 90° will give the best performance.
t
c40°
r
DEVO 7E - 1 1
Advertisement
Table of Contents
