Table of Contents
Advertisement
Elevator trim
1.11-11FayLionli II I I
-I
Throttle trim
Transmission power display
Tool
ii l
[ . . 1
I
Display
C:ontrast
Li 9 htn ess
7
r 1 '1
/10
cleUention
DEVO 7E
Welcome to use the DEVO 7E transmitter
1.0 System Menu
This section describes the settings which are specific to the operation of the DEVO 7E itself. Settings for
Language, Display, Buzzer, vibrator, Stick Mode, Stick Direction, Stick Calibration and About (Firmware) can
all be accessed via the System menu.
Below is the boot screen of helicopter:
Timer display
Throttle percentage
value
Rudder trim display
Battery charge
indicator
Model name
Model type
display
Aileron trim
display
1.1 Setup Language
Choose the native language for the DEVO 7E. Here is the setup: Press ENT to enter System Menu and
then press UP or DN to move the navigational mark to select System menu. Then push ENT to enter System
menu. Press UP or DN to select Language and press ENT to enter the language interface. Press UP or DN
to select the language that you desire. A " 4" will be shown on the screen after selected. Push EXT to exit.
Language
ritf$
Dputsch
Fran
!E;
1.1 Language setup
1.2 Display
1.2 Display
Three items are available to be set for Display:
(1) Backlight contrast: the backlight contrast is adjustable by using UP or DN buttons to move the navigational
mark to the digits after Contrast. Press R key to increase the backlight contrast, while press L to decrease it.
(2) Backlight intensity: the backlight intensity is adjustable using the up or DN buttons. Power consumption
will be increased when intensity is high and battery life will be reduced. When the value is one means
tum off the backlight.
(3) Backlight timeout: the duration for which the LCD stays lit can be configured from 5 to 60 seconds in 5
second intervals or set to "Always On".
Below are the setup:
Press ENT to enter the main menu, use UP or DN to move the navigational mark to select system menu.
Press ENT to enter the System sub-menu, use UP or DN to select Display to enter "DISPL" interface.Press
DN to enter the Backlight time-out setting, use R or L to adjust the period up to 60 seconds, using a setting
of 0 means always on. Press ENT to confirm and EXT to exit to main menu.
Press EXT to exit.
DEVO 7E —
14
Advertisement
Table of Contents
