Drawbar Hitch Rotatable Towing Yoke (Dh-Зv) - Belarus 922.6 Operator's Manual

4.4.3 Drawbar hitch rotatable towing yoke (DH-ЗV)
Figure 4.4.2 – Installation variants scheme of towing yoke
Table 4.4.2 – Basic parameters and coupling dimensions of towing yoke
DH type
1 Mounting location
2 Design features
3 Purpose
4 DH yoke dimensions, mm:
а) connecting pin diameter
1
b) yoke position
rear PTO shaft
c) distance between PTO shaft end extension
and connection pin axis
5 Trailing appliance for connection to DH:
а) type
b) vertical load in hitch point, kN, not more
than
c) trailing appliance steering angle in horizon-
tal plane, degrees, not less than
d) protective mean type
e) connection point of a protective mean to the
tractor
f) Relative calculated value of axial forces (D),
kN, not more than
6 Designation
7 EU certificate type
8 EU type approval, No
________________________________________________________________________
__________________________
1)
Recommended.
2)
Implement accessories.
ATTENTION: IT IS FORBIDDEN TO PUT YOKE TO A POSITION WHERE ITS BODY
OVERHANGS THE DH SUPPORTING BRACKET END FOR MORE THAN 15 ММ!
for the implements driven by
Rotational, height adjustable
For connection and coupling of trailed
implements, including of tractor trailers
equipped with drawbar clevises
Lower position as it is shown in Figure
Rigid, with tractor drawbar clevis
Safety chain (rope)
Lifting device bores
1321-2707050-B1
1321-2707050-B1
e1*89/173*2006/26*420*00
105
922.6-0000010 OM
Yoke
Rear lifting device
30
4.4.2
400
12
±60
2)
56,1