Drawbar Hitch Dh-Зv (Long Towing Yoke) - Belarus 1523.5 Operator's Manual

4.4.3 Drawbar hitch DH-ЗV (long towing yoke)
Figure 4.4.2 – Installation variant diagram of DH-ЗV (long towing yoke)
Table 4.4 – Basic parameters and coupling dimensions of DH-ЗV (long towing yoke)
Standard size (configuration)
1 Mounting location
2 Design features
3 Assignment
4 DH yoke dimensions, mm:
а) connecting pin diameter
b) yoke position
by rear PTO shaft
c) distance between the PTO butt end and
the connecting pin axis
5 Trailing device for coupling to DH:
а) type
b) vertical load in hitch point, kN, not more
than
c) turning angle of the implement trailing de-
vice in horizontal plane, degrees, not less
than
d) protective device type
e) connection point of the protective device
on the tractor
_____________________________________________________________________
_____________________________
1)
Recommended.
2)
Implement accessories.
ATTENTION: IT IS FORBIDDEN TO PUT DH-3V YOKE TO A POSITION WHERE ITS
BODY OVERHANGS THE DH SUPPORTING BRACKET END (UP AND DOWN) FOR
MORE THAN 15 ММ!
1)
for the implements driven
DH -3V (long towing yoke)
Rear lifting device
Rotational, height adjustable
For coupling of trailed implements, in-
cluding tractor trailer type equipped with
drawbar clevises
40
Extreme lower position, as shown in
figure 4.4.2
400
Rigid, with tractor drawbar clevis
20
±60
Safety chain (rope)
Lifting device openings
111
1523.5-0000010 OM
2)