Drawbar Hitch Dh-2V - Belarus 1822.3 Operator's Manual

5.4.2 Drawbar hitch DH-2V

Figure 5.4.1 – Installation variants scheme of DH-2V
Table 5.3 – Basic parameters and coupling dimensions of DH-2V
Standard size (configuration)
1 Variant
2 Mounting location
3 Design features
4 Purpose
5 DH yoke dimensions, mm:
) connecting pin diameter
b) yoke gap height
c) yoke gap width
1)
d) yoke position
rear PTO shaft
e) distance between PTO shaft end extension
and connection pin axis, mm
6 Trailing appliance for connection to DH:
) type
b) vertical load in hitch point, kN, not more than
c) trailing appliance steering angle in horizontal
plane, degrees, not less than
d) protective mean type
e) connection point of protective mean to the
tractor
_________________________________________________________________________________________________
1)
Recommended.
2)
Implement accessories.
ATTENTION: IT IS FORBIDDEN TO PUT DH-2V YOKE TO A POSITION WHERE
ITS BODY OVERHANGS THE DH SUPPORTING BRACKET END FOR MORE THAN 15
!
for the implements driven by
https://tractormanualz.com/
DH-2V (Towing yoke)
Yoke acc. to ISO Yoke acc. to GOST
Rear lifting device
Nonrotational, hight adjustable
For connection and coupling of trailed,
semitrailed implements with traveling
wheels including of tractor semitrailer
type
Lowermost position
110
Rigid, with tractor drawbar clevis
Safety chain (rope)
Lifting device bore
198
2022.3-0000010 OM
40
85
70
160
25
±60
2)