Server Warnings And Cautions - HPE ProLiant DL160 Gen10 Maintenance And Service Manual

CAUTION: CAUTION:
Always plan the rack installation so that the heaviest item is on the bottom of the rack. Install the heaviest item first, and
continue to populate the rack from the bottom to the top.
CAUTION: CAUTION:
Before installing the server in a , be sure to properly scope the limitations of the . Before proceeding with the installation,
consider the following:
You must fully understand the static and dynamic load carrying capacity of the
the weight of the server.
Be sure sufficient clearance exists for cabling, installation and removal of the server, and movement of the rack doors.

Server warnings and cautions

Server warnings and cautions
WARNING: WARNING:
To reduce the risk of personal injury, electric shock, or damage to the equipment, disconnect the power cord to remove
power from the server. Pressing the Power On/Standby button does not shut off system power completely. Portions of the
power supply and some internal circuitry remain active until AC power is removed.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system components to WARNING:
cool before touching them.
WARNING: WARNING:
To reduce the risk of fire or burns after removing the energy pack:
Do not disassemble, crush, or puncture the energy pack.
Do not short external contacts.
Do not dispose of the energy pack in fire or water.
Do not expose the energy pack to low air pressure as it might lead to explosion or leakage of flammable liquid or gas.
Do not expose the energy pack to temperatures higher than 60°C (140°F).
After power is disconnected, battery voltage might still be present for 1s to 160s.
CAUTION: CAUTION:
Protect the server from power fluctuations and temporary interruptions with a regulating UPS. This device protects the
hardware from damage caused by power surges and voltage spikes and keeps the server in operation during a power
failure.
CAUTION: CAUTION:
To prevent damage to electrical components, properly ground the server before beginning any installation, removal, or
replacement procedure. Improper grounding can cause electrostatic discharge.
CAUTION: CAUTION:
To avoid data loss, Hewlett Packard Enterprise recommends that you back up all server data before installing or removing
a hardware option, or performing a server maintenance or troubleshooting procedure.
CAUTION: CAUTION: Do not operate the server for long periods with the access panel open or removed. Operating the server in this
manner results in improper airflow and improper cooling that can lead to thermal damage.
and be sure that it can accommodate
HPE ProLiant DL160 Gen10 Server Maintenance and Service Guide 33