®
Advanced Energy
Rotate the MODIFY knob to select Yes or No and press ENTER to accept and exit.
Check the passive front panel displays on your slave units to view the individual slave
numbers.
Note: This function can only display numbers for up to 15 slave units. If your system
has greater than 15 units, the slave number does not display on the additional
units.
CHECKING YOUR MASTER/SLAVE SYSTEM FOR FAULTS
SERVICE → DEBUG → SYSTEM
Displays master/slave system size and number of slaves in system.
SERVICE → DEBUG → SYSTEM → FAULTS
Rotate the MODIFY knob to display master faults and slave faults individually. Use
this option to check logic and master/slave card faults on master and slave(s).
SERVICE → DEBUG → SYSTEM → UNITS
Rotate the modify knob to display output power and output current of each unit in the
master/slave system. Use this option to check output levels of individual units in the
master/slave system.
CHECKING YOUR HARDWARE CONFIGURATION
SERVICE → DEBUG → HW CONFIG
To find out whether or not a card is installed in slot 1 or 2:
1. Press SERVICE → DEBUG → HW CONFIG.
4 A report of the personality cards installed in the supply in slot 1 and slot 2
appears.
CHECKING YOUR COMMUNICATIONS CARD
SERVICE → DEBUG → CARD
Use this option to find out specific communications debug information:
1. Press SERVICE → DEBUG → CARD.
Note: Not all cards support this feature.
CHECKING YOUR SOFTWARE LOGIC
SERVICE → DEBUG → LOGIC
Use this option to find out what software logic options are installed.
1. Press SERVICE → DEBUG → LOGIC.
4-26
I/O Communication and Control
5702156-E