Mitsubishi Electric MELSERVO HF-MP Instruction Manual page 36

3. CONNECTORS USED FOR SERVO MOTOR WIRING
Connector
Feature
configuration
D IP67
Note. Use this connector if there is a potential risk that a high vibration may be applied to connectors. The connector on the servo
motor side can be disconnected up to 5 times. Use dedicated tool 357J-52780T (DDK) or a spanner with a jaw size of 21mm.
Type Plug
CMV1-AP10S-M1
(one-touch connection
type)
CMV1-AP10S-M2
Angle
(one-touch connection
type)
CM10-AP10S-VP-M
(Note)
Plug (DDK)
Socket contact
Soldering type
CMV1-#22ASC-S1-100 Applicable wire size:
AWG20 or less
Crimping type
Applicable wire size:
CMV1-#22ASC-C1-100 AWG24 to 20
The crimping tool (357J-
53162T) is required.
Crimping type
Applicable wire size:
CMV1-#22ASC-C2-100 AWG28 to 24
The crimping tool (357J-
53163T) is required.
Soldering type
CMV1-#22ASC-S1-100 Applicable wire size:
AWG20 or less
Crimping type
Applicable wire size:
CMV1-#22ASC-C1-100 AWG24 to 20
The crimping tool (357J-
53162T) is required.
Crimping type
Applicable wire size:
CMV1-#22ASC-C2-100 AWG28 to 24
The crimping tool (357J-
53163T) is required.
Soldering type
CM10-#22SC(S1)(D8)-
Applicable wire size:
100
AWG20 or less
Crimping type
Applicable wire size:
CM10-#22SC(C1)(D8)-
AWG22 to 20
100
Connection tool (357J-
50446T) is necessary.
Crimping type
Applicable wire size:
CM10-#22SC(C2)(D8)-
AWG28 to 23
100
Connection tool (357J-
50447T) is necessary.
3 - 7
Cable OD
Contact shape
[mm]
5.5 to 7.5
7.0 to 9.0
6.0 to 9.0
Servo
motor
encoder
connector
CM10-R10P