Introduction
Contents
Overview
This section contains information on the following topics:
Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
This document describes the procedures used to install and configure a
Large System. For proper installation, perform the steps in the sequence
stated in "Summary of procedures." The summary will refer you to other
sections within this document. After completing the steps listed in those
sections, return to the summary and continue on to the next step.
Whenever possible, install external power equipment before the system
installation. If reserve power equipment is used, install it according to the
manufacturer's instructions.
To install telephones and attendant consoles, see Telephones and Consoles:
Description (553-3001-367).
System installation must be performed by qualified personnel only.
Large System
Installation and Configuration
Page 15 of 376
15
16