Table of Contents
Advertisement
6. Insert a full bobbin into the hook in such a way that the supply groove (1)
Important
Insert the bobbin such that the bobbin number (7)/the bobbin barcode (6)
is facing up.
The basin for the bobbin spring is found on the bottom.
7. Close the bobbin case retainer (8).
8. If a barcode scanner for the bobbin barcode (3) has been assembled,
9. Enter the bobbin number (2) on the control panel or scan the bobbin
10. Slide the hook cover (4) back to the left.
Information
The remaining thread monitor is not active unless it has been activated in
the machine configuration: Check - DacFlex Commander. Refer to
the Operating Instructions D867, chapter Programming, for detailed
instructions.
4.1.8 Threading the hook thread
34
is pointing down and the rotational direction for pulling off the thread
is counterclockwise.
pull the bobbin by the hook into a position where the bobbin barcode (3)
can be scanned.
barcode (3).
WARNING
Risk of injury from moving, cutting and sharp
parts!
Crushing, cutting and punctures are possible.
Only thread the hook thread with the machine
switched off.
NOTICE
Property damage may occur!
Damage and malfunction of the sensor.
Every time you change the bobbin, use compressed air to remove
sewing dust from the area around the bobbin case and the sensor
of the remaining thread monitor.
Operating Instructions 550-D800 - 01.0 - 05/2023
Operation
Advertisement
Table of Contents
