Table of Contents
Advertisement
Programming
Information
If you entered, for instance, 20 as the number of stitches, the sensor will,
starting with the 1
remain inactive until this number has been reached.
This function may prove useful, for instance, if you sew a bartack prior to
a documented seam or sewing material that is particularly fluff or has
particularly unclean edges.
5. Confirm with
To set the seam section switch via number of stitches:
1. Open the Seam record set display ( p. 99).
2. Press the Stitches button.
The checkmark confirms the selection.
3. Press the input field.
The display switches to Stitches.
4. Enter the desired number of stitches.
5. Confirm with
To set the seam section switch via manual operation:
1. Open the Seam record set display ( p. 99).
2. Press the Manual button.
The checkmark confirms the selection.
Defining the length of the documented seam section
Here, you enter the length of the documented seam section in mm. It is
advisable to define the length of the documented seam section for a seam
record set. The length is required, for instance, whenever the exact stitch
length needs to be specified in the data protocol or this information is
supposed to be printed on the end label.
While possible, defining the length of the free seam sections is of less
importance.
To set the length of the documented seam section:
1. Open the Seam record set display ( p. 99).
2. Press the Total length input field.
An input window appears.
3. Enter the desired length (mm).
4. Confirm with
Operating Instructions 550-D800 - 01.0 - 05/2023
st
notch, be deactivated for 20 stitches. The sensor will
.
.
.
105
Advertisement
Table of Contents
