Table of Contents
Advertisement
Operation
Information
The hook thread is normally wound on when sewing is in progress.
However, you can also wind on the hook thread without sewing, e. g. if you
require a full bobbin in order to start sewing. For this purpose, use Bobbin
Wind mode in Manual mode.
11. Pull off the full bobbin.
12. Tear off the thread behind the knife (7).
13. Cut off the surplus left after winding on the thread.
14. Insert the full bobbin into the hook ( p. 32).
15. If a scanner has been assembled, the barcode of the bobbin will be
Fig. 17: Winding the hook thread (4)
16. Enter the bobbin number.
Information
Verify that the bobbin number (6) you entered is correct before you press
the
17. Confirm with
Operating Instructions 550-D800 - 01.0 - 05/2023
scanned automatically - without a scanner, the following window will
be displayed:
button.
.
31
Advertisement
Table of Contents
