Table of Contents
Advertisement
Linking a picture file
Each seam record set can be linked to an image (picture file).
If the machine is used to process different sewing materials, e.g. driver
and passenger seat covers, the corresponding seam program can be
linked to an image of the driver / passenger seat cover. This image must
be confirmed with OK before sewing starts as the machine will otherwise
not be able to sew the seam record set.
The image of the seam record set will be displayed at the start of the sew-
ing process.
To link an image to a seam record set:
1. Open the Seam record set display ( p. 99).
2. Press the PictureFile input field.
The directory holding the images that are stored on the control panel
3. Select the desired image.
4. Confirm with OK.
Setting start and end bartack
Here, the start and end bartack are defined in detail. There are three op-
tions each:
• no start/end bartack
• single start/end bartack
• double start/end bartack
Setting no start/end bartack
To specify that there will be no start/end bartack:
1. Open the Seam record set display ( p. 99).
2. Press the no button below the heading Start/end tack.
Setting a single start/end bartack
To set a single start/end bartack:
1. Open the Seam record set display ( p. 99).
2. Press the single button below the heading Start/end tack.
3. Enter the desired number of stitches.
108
opens.
The top two entries under the heading Tack stitches are reset
to 0 for the start/end bartack.
Operating Instructions 550-D800 - 01.0 - 05/2023
Programming
Advertisement
Table of Contents
