Dürkopp Adler 550-D800 Operating Instructions Manual page 109

Programming
Linking a teach-in file
A thread tension teach-in file is used to store all data necessary to set the
tolerance for the electronically regulated thread tension (for ETT only).
This teach-in file is created ( p. 181), stored on the control panel and
can be linked to each seam record set.
To link a teach-in file to a seam record set:
1. Open the Seam record set display ( p. 99).
2. Press the Thread.Tens.Teach-In input field.
 The directory holding the teach-in files that are stored on the control
3. Select the desired teach-in file.
4. Confirm with OK.
5. To bring up and view the settings, press the Edit button.
Linking a label script file
Stored in a label script file is all relevant data about the end label. Such a
label script file can be created directly in the software ( p. 159) or using
the Label Creator ( p. 189) and then saved on the control panel before
being linked to each seam record set.
To link a label script file to a seam record set:
1. Open the Seam record set display ( p. 99).
2. Press the LabelScript input field.
 The directory holding the label script files that are stored on the con-
3. Select the desired label script file.
4. Confirm with OK.
5. To bring up and view the settings, press the Edit button.
Information
If a label script file is linked to a seam record set, all other settings regard-
ing the end label will be overwritten by the information stored in the file.
Operating Instructions 550-D800 - 01.0 - 05/2023
panel opens.
trol panel opens.
107