Table of Contents
Advertisement
10. Insert the thread through the hole in the lower thread guide (9).
Information
For machines with thread clamp (optional)
11. Insert the thread through the right hole of the guide above the thread
12. Insert the thread through the right hole of the guide below the thread
Fig. 14: Thread clamp
13. Insert the thread into the thread clamp from the right so that the thread
The thread is supposed to run through the clamp almost without touching
it and in such a way that it only makes contact with the guides above and
below the thread clamp.
14. Insert the thread through the thread guide (8) on the needle bar block.
15. Insert the thread through the needle eye (towards the groove) in such
16. Pull the thread through the needle eye until the loose thread end has
Important
Check the thread length.
If the loose thread end is too long, the thread may be caught by the hook
and cause a disturbance. If the loose thread end is too short, the machine
cannot start sewing.
28
clamp.
clamp.
is held in place inside the hook of the clamp.
a way that the loose thread end faces the hook.
a length of approx. 4 cm with the thread lever (14) at the highest position.
Operating Instructions 550-D800 - 01.0 - 05/2023
Operation
Advertisement
Table of Contents
