Table of Contents
Advertisement
Operation
Needle and hook thread are each fed through the hose guide from the reel
stand to the tensioning plate (needle thread) / to the winder (hook thread).
To feed the needle/hook thread through the hose guide:
1. Fit the thread reel (1) on a thread reel holder.
Information
If the needle/hook thread barcode (2) is not detected by the barcode scan-
ner (3), a message will appear on the control panel.
If this happens, align the thread reel (1) anew and scan the needle/hook
thread barcode (2) again.
Fig. 10: Feeding needle and hook thread (4)
(4) - Thread advancing device
2. Feed the wire of the thread advancing device (4) through the slot (5)
3. Tie on the needle/hook thread and pull it through the hose guide manually.
You can now thread the needle/hook thread ( p. 26 and p. 34) and
set the thread tension ( p. 36).
Operating Instructions 550-D800 - 01.0 - 05/2023
Make sure that the needle/hook thread barcode (2) can be scanned
by the barcode scanner (3).
and up to the reel stand.
(5) - Slot
⑤
④
25
Advertisement
Table of Contents
