Changing The Barcode Type - Dürkopp Adler 550-D800 Operating Instructions Manual

Barcode
ID.- part 1
ID.- part 2
ID.- part 3
ID.- left side
front
ID.- right side
front
ID.- left side rear
ID.- right side
rear
Id. other

5.10.3 Changing the barcode type

Fig. 151: Changing the barcode type
Here, you can select which barcode type is supposed to be used for the
following barcodes (1D or 2D):
• Barcode parts primary
• Barcode of the needle thread reel (Barcode used needle thread)
• Barcode of the hook thread reel (Barcode used bobbin thread)
To change the barcode type:
1. Log in with security level 2 ( p. 75).
2. Open the Setup display ( p. 132).
3. Open the Barcodes display ( p. 156).
4. Press the Primary barcode type input field.
 A drop-down menu opens.
5. Select the desired barcode type.
158
Stored information
Here, you define a designation for the 1
This designation may consist of numbers and/or letters. The designation
must be found as specified at the defined place in the barcode parts
st nd
primary of the 1 , 2 and 3
different.
Here, you specify whether the 1
the left or the right. The entered value must be found as specified at the
defined place in the barcode parts primary of the 1
sewn.
Here, you can store an additional piece of information regarding the 3
piece to be sewn. The entered value must be found as specified at the
defined place in the barcode parts primary of the 3
st nd rd
, 2 and 3 piece to be sewn.
rd
piece to be sewn. All 3 IDs must be
st nd
/ 2 piece to be sewn is located on
st
/ 2
rd
piece to be sewn.
Operating Instructions 550-D800 - 01.0 - 05/2023
Programming
nd
piece to be
rd