Table of Contents
Advertisement
Component
Winder
Read bobbin number
with fixed scanner
Scanner on the seam
Needle thread sensor reel
(Sensor needle thread
cone)
Bobbin thread sensor reel
(Sensor bobbin thread
cone)
Multi barcodes
With UPS control
Needle control
Multi barcode with
batch mode
Store single stitch
data in SAB seam
Thread tension
single stitch
checking
Calibration control
Thread tension
graphics
Thread tension
regulator on
Edge measuring
Tack stitches for
each seam section
136
Function
Motorized winder
Bobbin identification by barcode (optional)
End label identification by end label scanner (optional)
Monitoring of the needle thread reel by proximity switch.
The sensor detects when the needle thread reel has been
removed.
The needle thread barcode is scanned using the hand
scanner.
Monitoring of the hook thread reel by proximity switch.
The sensor detects when the hook thread reel has been
removed. The hook thread barcode is scanned using the
hand scanner.
Apart from the barcodes parts primary, it is also possible to
request up to 9 multi barcodes at the beginning of the sew-
ing process
Automatic switch to battery power when the power supply
has been interrupted p. 151
Set when the needle is supposed to be checked and/or
changed. The needle database cannot be viewed unless
this function is enabled p. 142
Batch mode makes it possible to scan the barcodes parts
primary and the multi barcodes and, subsequently, sew
repeatedly without the need to scan the barcodes again
p. 162
The batch size is used to define how many sewing
processes are supposed to be completed before the
barcodes will be requested again.
Saving the thread tension values of each needle stitch in a
documented seam section to a TXT file
Definition as to whether the number of stitches outside of
the tolerance must be distributed in sequence or along the
entire seam
Regular check of the stepper motor / the thread force
sensor
Visualization of the thread tension during the sewing pro-
cess
If the machine is used with an ETT, the TARGET and the
ACTUAL values of the thread tension will be compared,
and the thread tension will be corrected (regulated) auto-
matically during sewing ( Operating Instructions)
Additional equipment used to detect/monitor the distance
of the needle to the material edge
Allows for setting different tack stitches for start and end
bartack in the respective seam sections
Operating Instructions 550-D800 - 01.0 - 05/2023
Programming
Advertisement
Table of Contents
