Table of Contents
Advertisement
21. Press the T.Tens.below Target button again to allow the stepper motor
22. Press the T.Tens.above Target button.
The value of the needle thread tension is adopted.
23. Use a thread tension scale (1) to check the needle thread tension.
24. Adjust the percentage of the needle thread tension (Position step
25. Press the T.Tens.above Target button again to allow the stepper motor
26. Press the next Step button.
The display switches to:
Fig. 175: Creating a teach-in file (3)
Step 1 and step 2 are now highlighted in green and yellow,
27. Press the Start Sewing button.
If the test seam was completed successfully, the display switches to:
Fig. 176: Creating a teach-in file (4)
184
to set the specified value.
motor) until the measured value matches the setpoint:
• lower value: lower needle thread tension
• higher value: higher needle thread tension
to set the specified value.
respectively.
Operating Instructions 550-D800 - 01.0 - 05/2023
Programming
Advertisement
Table of Contents
